Table of Contents
Advertisement
reboot during restart to change state of device.
The optional settings: [None]; [TPM Clear].
►
ACPI Settings
Press [Enter] to make settings for the following sub-items:
ACPI Settings
ACPI Sleep State
Use this item to select the highest ACPI sleep state the system will enter when the
suspend button is pressed.
The optional settings are: [Suspend Disabled]; [S3 (Suspend to RAM)].
►
PCH-FW Configuration
Press [Enter] to view ME information and make settings in the following sub-items:
TPM Device Selection
Use this item to select TPM device.
The default setting is: [PTT].
[PTT]: Enable PTT in SkuMgr.
►
Firmware Update Configuration
Press [Enter] to make settings for 'ME FW Image RE-Flash'.
ME FW Image Re-Flash
Use this item to enable or disable ME FW Image Re-Flash function.
The optional settings: [Disabled]; [Enabled].
* In the case that user needs to update ME firmware, user should set 'ME FW
Image Re-Flash' as [Enabled], save the settings and exit. The system will turn off
and reboot after 4 seconds. If the user goes to BIOS screen again will find this item
is set again as [Disabled], but user can still re-flash to update firmware next time.
►
Wake-up Function Settings
Press [Enter] to make settings for the following sub-items:
Wake-up System with Fixed Time
Use this item to enable or disable system wake on alarm event.
The optional settings: [Disabled]; [Enabled].
When set as [Enabled], system will wake on the hour/min/sec specified.
Wake-up System with Dynamic Time
29
Hide quick links:
Advertisement
Table of Contents
