Table of Contents
Advertisement
Broadcom BCM943364WCD1 C-SDK Setup Guide (v 1.0)
are the standard "SteamSensor" example properties, compiled and running as a simulator on the device.
They include Temperature and Pressure.
Click "Add All Above Properties" to add these properties to the Thing, and then click "Done".
After saving and refreshing, you should see properties updating on the Thing from the Properties page.
5.
For additional help, refer to the Troubleshooting section below.
12
Advertisement
Table of Contents
Need help?
Do you have a question about the ThingWorx Broadcom BCM943364WCD1 C-SDK and is the answer not in the manual?