Operating Procedures - Westinghouse TR15142 Instruction Manual

FUEL
• The trimmer is equipped with a two -stroke engine. Always run the engine on fuel, which is mixed
with oil.
• Provide good ventilation, when fueling or handling fuel.
• Always use branded 90 octane unleaded gasoline.
• Use a quality two-cycle oil at mixing ratio of 25:1 (Gasoline (A): Oil (B)).
• Never use multi-grade oil (10 W/30) or waste oil.
• Always mix fuel and oil in a separate clean container.
Always start by filling half the amount of fuel, which is to be used. Then add the whole
amount of oil. Mix (shake) the fuel mixture.
Add the remaining amount of fuel.
Mix (shake) the fuel-mix thoroughly before filling the fuel tank.
FUELING
Before fueling, clean the tank cap area carefully, to ensure that no dirt falls into the
tank.
Make sure that the fuel is well mixed by shaking the container, before fueling.
• Always shut off the engine before refueling.
• Slowly open the fuel tank, when removing cap, so that possible over -pressure disappears.
• Tighten the fuel cap carefully, after fueling.
• Always move the engine/equipment at least 3m (10ft.) from the fueling area before starting.

OPERATING PROCEDURES

WARNING!
WARNING!
DANGER!
DANGER!
6