Assembly Procedures - Westinghouse TR15142 Instruction Manual

ASSEMBLY PROCEDURES

1-1 1-2 1-3 1-4
ASSEMBLE THE HANDLES (Fig. 1-1)
• Loosen the 4 bolts on the upper shaft
• Insert the handle
• Push on the handles as desired
• Tighten the 4 screws with the 5mm Allen Key.
REPLACE THE CUTTING BLADE (Fig. 1-2, 3)
• Ensure the brush cutter is switch off and be sure the engine full stopped.
• Insert a prevent rotational wrench or equivalent into the back shield and the adaptor
semicircle hole to prevent the output shaft from turning.
• Loosen the nut with the socket wrench (T-Wrench) by turning counterclockwise (view
from top), then remove spring washer, washer, cover cap, spacer and cutter blade from
the output shaft.
• Replace the cutter blade, install the blade, by aligning the center of the blade with the
shoulder on cover spacer A.
• Install spacer C, the cover board, the washer and spring washer, then tight the nut.
• Remove the prevent rotational wrench or equivalent from the back shield and adaptor.
INSTALL THE TRIMMER HEAD (Fig. 1-2, Fig. 1-4)
• Ensure the brush cutter is switch off and be sure the engine full stopped.
• Insert a prevent rotational wrench or equivalent into the back shield and the adaptor
semicircle hole to prevent the output shaft from turning.
• Loosen the nut with S5 wrench by turning counterclockwise (view from top), then
remove spring washer, washer, cover cap, spacer and cutter blade from the output
shaft.
• Insert the shield on the fixed bracket, tighten the screw.
• Tighten the Spool & Line Assembly on the machine head bolt by turning clockwise.
5