Caller Id Display And Panel Buttons; Opx Type Calls; Call Waiting Caller Id; Automatic Caller Id Call Routing - Digitone proseries blocker Operation Manual

Automatically blocks and routes screened calls with caller id

Hide thumbs

Table Of Contents

Table of Contents

OPX Type Calls

- OPX calls display as: Out of Area, Private and "X", Unknown or Anonymous calls

that do not have a minimum 7 digit number displayed, or have characters in the number like # or *. The

factory setting is to hang-up on these types of calls.

Call Waiting Caller ID

Blocked list will not be blocked because you are on the phone line. Blocked callers only hear ringing and

you will see who is calling on your phone's display, but not on the DPB display. You can however,

answer invited callers that ring-in through Call Waiting using your Flash key or Switch Hook.

Automatic Caller ID Call Routing

Caller ID service from your phone company

is required for Digitone's DPB to work. The

first call to your DPB unit will initialize the

Clock and Date to the current date and

time. Automatic call routing will begin to

work right after the first call when Caller ID

information is displayed. Note that during

Daylight Savings Time changes, the

phone company is responsible for updating

their clock data when delivering the caller

ID information.

Caller ID Display Icons

The "N" on the upper left of the display is

for New calls and the red LED flashes until

this is reduced to 0. The telephone icon shows the line is either on-hook or offhook or if the call was

already answered. The VIP icon indicates a caller in the VIP List has called in. To the right is the time

and date, then "T" for Total calls currently in Call History.

Voice Mail & Message Waiting

There is an envelope icon above the VIP icon that indicates a message waiting if you have this service.

The DPB automatically relays any incoming Message Waiting notification to your phones connected to the

TEL port.

Protected Mode – Call History Button

The display is normally in Protected Mode, when the DPB is sitting idle and the front panel buttons are

locked. Numbers are shown on the display without dashes to prevent accidental number entries to a list.

To enable the front panel buttons and add Blocked, Invited or VIP list entries, you must first use the

Call History Up or Down viewing buttons to select a displayed number which will then show the

numbers with dashes between the digits, Ex. 894-555-5555. This allows you to add a number to a list.

Block Button

RED

You can block a new caller after the 2nd ring and stop the call just by pressing the Block button Twice

quickly. DO NOT HOLD the Block button down! The red LED will flash to indicate the call has been

answered, the display will show the "NBR Blocked" and will then be added to the Blocked Callers List.

Block Button

RED

Blocked Callers can be entered by First using the Call History Up or Down viewing buttons to put the

dashes in the selected number, then pressing the Block button Twice quickly on the front panel.

"NBR Blocked" will display and the red LED indicator will flash to show that call is now on the Blocked

Call List. "Blocked" will display with the LED flashing to show when that caller has been hung up on.

– When on the phone, and you hear the Call Waiting signal, callers on your