Sennheiser PXC 550 Instruction Manual page 20

Getting started
18 | PXC 550
Pairing the headphones with a Bluetooth device
Ensure that your PXC 550 headphones are within the 20 cm range of your
smartphone. Also ensure that the headphones and the Bluetooth switch are in
the "on" position when performing this procedure.
1. Switch the headphones on or unfold the headphones to ready-to-wear
position (see page 23). Press the
the voice prompt "pairing"
a running display.
The headphones are in pairing mode.
At this point, if you decided to not proceed with the pairing, just press the
Sound button once. You will hear the voice prompt
after a few seconds.
2. Enable the Bluetooth visibility on your smartphone.
3. On your smartphone, start a search for Bluetooth devices.
All active Bluetooth devices in the proximity of your smartphone are
displayed.
4. From the list of found Bluetooth devices, select
Bluetooth connection to the headphones. If necessary, enter the default PIN
code "0000".
If pairing is successful, you hear the voice prompt "pairing successful" and a
LED flashes white 3 times.
› power on ‹
› pairing ‹
20 cm
Menu
Add device
› connected ‹
If no connection is established, you hear the voice prompt "no connection".
After attempting to connect for 5 minutes, pairing mode is terminated and
the headphones return to the disconnected state.
off and repeat the pairing procedure.
Sound button 4 seconds until you hear
and the 5-LED-array repeatedly flashes white in
"PXC 550"
3X
Switch the headphones
"pairing cancelled"
to establish a
Menu
Bluetooth on
Bluetooth off
PXC 550
PXC 550
Keyword: 0000