Introduction; Introduction; Required Tools & Equipment - SkyStream 3.7 Owner's Manual

2
One - Introduction
These instructions require use of Southwest Windpower's Hinge and Gin Pole Kits, which were specifically designed for this application.
Additionally, these instructions assume a bolt kit was purchased and the correct foundation nuts, bolts and washers are available.
Once the tower is raised into position the hinge and gin pole are removed. It is therefore not necessary to purchase these items. Should
it be necessary to lower the tower, the hinge and gin pole may be reinstalled and used to lower and raise the tower.
1-1 Required Tools & Equipment
The following tools and equipment are necessary to install the tower:
• Hinge Mounting Kit - Part Number 3-CMBP-3063
• Gin Pole Kit - Part Number 3-CMBP-3054
• 16 Flat Washers, 1 1/4" ID, galvanized SATM F436, (SWWP part number 3-HDWA-917)
• 19 Nuts, 1 1/4", galvanized, (SWWP part number 3-HDNT-908)
• Bubble level, (easier with two levels)
• Pair of 2" open end wrenches.
• Pair of adjustable wrenches to install hinge plates and gin pole, tape measure.