1.
REMOVAL OF MECHANICAL PARTS
AND P.C. BOARDS
1-1:
TOP CABINET AND FRONT CABINET
(Refer to Fig. 1-1)
Remove the 5 screws 1.
1.
2.
Remove the Top Cabinet in the direction of arrow (A).
3.
Disconnect the following connector: (CP651).
Unlock the 8 supports 2.
4.
5.
Remove the Front Cabinet in the direction of arrow (B).
Remove the 2 screws 3.
6.
7.
Remove the Operation PCB in the direction of arrow (C).
1
Front Cabinet
(B)
2
2
3
2
2
2
(C)
2
2
2
1-2: FLAP (Refer to Fig. 1-2)
1.
Open Flap to 90˚ and flex in direction of arrow (A), at the
same time slide in direction of arrow (B).
2.
Then lift in direction of arrow (C).
(C)
DISASSEMBLY INSTRUCTIONS
1
Top Cabinet
1
(A)
1
3
CP651
Operation PCB
Fig. 1-1
(A)
(B)
Flap
Fig. 1-2
1-3: DVD DECK (Refer to Fig. 1-3)
1.
Make the short circuit on the position as shown Fig. 1-3
using a soldering. If you remove the DVD Deck with no
soldering, the Laser may be damaged.
Unlock the support 1 and remove the Deck Top Holder
2.
in the direction of arrow (A).
Remove the 2 screws 2.
3.
Remove the screw 3.
4.
Remove the screw 4.
5.
6.
Disconnect the following connectors: (CP2601, CP2602,
CP2603).
7.
Remove the DVD Deck in the direction of arrow (B).
Remove the 3 screws 5.
8.
9.
Remove the Front Angle in the direction of arrow (C).
Remove the screw 6.
10.
11.
Remove the DVD Angle.
1
Deck Top Holder
5
5
5
NOTE
When the installation of the DVD Deck, remove all the
soldering on the short circuit position after the connection of
Pick Up PCB and DVD PCB connector.
Pick Up PCB
4
DVD Deck
3
2
1
2
(A)
(B)
Make the sort circuit
using a soldering.
DVD Angle
6
(C)
CP2601
CP2603
CP2602
Front Angle
Fig. 1-3
1-1