Front Panel Component Function Connect to your SDI Display or Device plug SDI Output Port 2 Ouputs Provided The LED's indicate Output Format LEDs indicate (SD/HD/3G/HDCP) Mode Buttons Select Format/TV Wall/TV Ratio Rear Panel Component Function Connect the Power adapter plug here. Power Jack Connect your HDMI Source to this input.
Buttons/LED Indicators 1. Button Mode: a. Format Mode: First press the #1 button to set the Output Format Mode (Resolution). Then change the Frame Rate by pressing buttons #2 and #3 as needed. FRAME RATE FRACTION By Pass 720x480 59.94i 720x576 59.94p 1280x720...
Page 7
TV Wall Mode: Pressing the #2 (Rate) button , will put the converter into the TV Wall Mode. You can change the window view by pressing the #3 (Fraction) button. Turn OFF Divide Windows To 2x2 Divide Windows To 3x3 Divide Windows To 4x4...
Page 8
c. Aspect Ratio Mode: Push Button 3 to change TV Ratio ↓:Display is 4:3 ↑:Display is 16:9 2. LED Mode: a. Output Mode: Resolution SD LED HD LED 3G LED HDCP LED NTSC(720x480) / ● ○ ○ ○ PAL(720x576) 720p / 1080i / ○...
Installation HDMI2SDI-Up/Down Scaler installation consists of the following: 1. Disconnect +12DC adaptor to converter. 2. Connect Video Source (HDMI) to the HDMI Connector. 3. Connect SDI Equipment to the BNCs connector 4. Connect the +12DC adaptor to the converter. Package Contents The HD2SDI-S package contains the following items: ...
Specifications DESCRIPTION SDI Format SD-SDI, HD-SDI & 3G-SDI SDI Transition Rate 2.970Gb/s, 10485Gb/s and 270Mb/s Audio Support Stereo 2-Channel Audio Sample Auto Ra-sample to 48Khz (For Stereo) RG6/RG59(75Ω ) Coaxial Cable Type 3G: 120m of RG6/ 100m of RG59 HD: 200m of RG6/ 140m of RG59 SD: 400m of RG6/ 280m of RG59...
Firmware Upload Firmware is upgradable in the field using the integrated USB port How to Firmware upgrade: Step 1. Open Upload Firmware Program tools.exe and connect box to PC by USB Cable. Step 2. Plug and un-plug “DC adapter” to power on/off the converter box (the connection check status will be changed to “Connect”)
Page 13
Step 3. Plug and un-plug “DC adapter” again (the connection check status will be changed to “Connected”) and Please click the Open File button to select the firmware bin file. Step 4. Please click “Start’ Button to proceed with new firmware programming. The PASS message will appear when the procedures finished.