FEATURES OF THE AMC MODEL X7i The AMC model X7i was designed to meet professional quality performance standard and to provide superior value. Selected grade components are utilized throughout the circuit design with special emphasis on components within the audio path to assure stable, consistent performance.
REAR PANEL CONNECTIONS/FRONT PANEL CONTROLS REAR PANEL SWITCHED 0.5A MAX 115W 230V 50Hz Stereo Receiver X7i PHONO SPEAKERS 230V 50Hz 1.5A ANTENNA TO iPod FM 75W CONNECTOR TAPE INPUT OUTPUT INPUT FRONT PANEL IMPEDANCE: A,B - 8 MIN A+B - 16 MIN 1.
Page 5
3.GROUND 9.SPEAKER OUTPUT A/B The separate turnable ground lead The X7i is equipped with 2 pairs of should be connected firmy to this pluggable Terminal Blocks allow quick GROUND terminal to minimize the connections of the internal amplifiers hum level.
Page 6
The maximum power is 120W (1A 120V 60Hz unit) and 115W (0.5A 230V 50Hz unit). Don't connect any power consumption over specified power equipment to UNSWITCHED AC OUTLET to prevent any dangerous may cause by over power. 12.AC RECEPTACLE The AC RECEPTACLE is for you to plug in with power cord attached in the packing.
13. VOLUME CONTROL 7. MODE 14. IPod INPUT 1. POWER ON/STANDBY Headphones are in use, both of When X7i is connected to AC manis, SPEAKER A/B shall be switched off. the STANDBY indicator LED will light up. Depressing the POWER 3.SPEAKER A/B...
1/8"(3.5mm) stereo jack plug. When During tuning mode, press up or down iPod socket is in use, switch INPUT to button for a while, X7i will search next "AUX" and a shorting U-link must be radio station automatically. plugged in AUX and "To iPod CONNECTOR ON FRONT PANEL"...
Page 9
An infrared (IR) system remote control is provided for convenience operation of the XCDi and AMC Receiver X7i. The handset provides X7i control functions listed in below. RC-S2...
Page 10
TUNE PRESET Tuning up or down of tuning mode or preset mode. During tuning mode, press up or down button for a while, X7i will search next radio station automatically. STEREO MONO Switch FM station into stereo or mono mode.
SAFETY INSTRUCTION 1. READ INSTRUCTIONS 16. DAMAGE REQUIRING SERVICE All the safety and operating instructions should be read The appliance should be serviced by qualified service before the appliance is operated. personnel when: a) The power-supply cord or the plug has been damaged; or 2.