Nice IT4WIFI Instructions And Warnings For Installation And Use page 14

Steady green
Flashing green Steady green
OFF OFF
OFF OFF
Green Green
Green, quick flash- OFF
ing
Green Orange
Flashing orange OFF
Error status
L1 LED L2 LED
OFF Steady red
Steady red
Steady red
Flashing red
To check LED behaviour when the Accessory is reset, see Table 7 - Chapter 8.
12 – English
Steady green Permanent
Steady green Temporary
(a few seconds)
Green Temporary
(a few seconds)
Steady green Permanent
Green, 8 quick flashes Temporary
Steady red Temporary
(roughly 30 seconds)
Green Temporary
(variable time)
Flashing orange Temporary
(roughly 1 minute)
L3 LED State
Steady red Permanent
Permanent
Permanent
Permanent or tempo-
rary
The Accessory is correctly associated with the
Wi-Fi network via which it was configured (in the
case of MyNice technology, connection to the
Cloud is also active)
The Accessory is searching for the automation
associated with it
The Accessory, already configured on the Wi-Fi
network, is starting up
The Accessory, if not configured on the Wi-Fi
network within 30 minutes of start-up, can no
longer receive the network configuration.
To restore it to that mode, disconnect it from the
power and then reconnect it
The Accessory has undergone an "Identify" ac-
tion by the user
The Accessory is loading the configuration for
correct operation
Wait for the operation to be completed
In the MyNice technology, the Accessory was
unable to connect to the Cloud or has lost the
connection to the Cloud.
The Accessory automatically restores the con-
nection as soon as it becomes available
The accessory is updating. Wait for the opera-
tion to be completed. If the operation is not
completed correctly, IT4WIFI automatically re-
starts after 5 minutes
Description
Problem: the Accessory has not started up
correctly
Solution: try to restart the Accessory, discon-
necting it from the power and then reconnect-
ing it.
If the problem reoccurs, carry out a Reset, re-
storing the factory settings, see Table 7 - Chap-
ter 8
Problem: the Accessory has acquired an in-
correct network configuration
Solution: carry out the first or second type of
reset detailed in Chapter 8
Problem: the Accessory has not found the au-
tomation associated with it
Solution: if present, try to install the Accessory
on another Gate&Door automation. If the prob-
lem reoccurs, replace the cable. If the problem
persists, the Accessory or Central unit is dam-
aged
Problem: the Accessory (already configured on
the network) has lost the Wi-Fi connection to
the Access Point
Solution: check that the Access Point is work-
ing and that other Wi-Fi devices are able to cor-
rectly connect to it, from the Accessory installa-
tion point. Check that the Accessory's antenna
is correctly installed. Check that the Accessory
is not shielded by any metal object that creates
interference with the connection. If the con-
nection cannot be restored in any way (Access
Point replaced or parameters modified), carry
out a total configuration Reset or Reset the Wi-
Fi credentials, see Table 7 - Chapter 8