Distributing The Sealant - Kia Niro 2018 Owner's Manual

What to do in an emergency
6. Ensure that the compressor is
switched off, position 0.
7 Connect between compressor and
the vehicle power outlet (4) using
the cable and connectors.
8. With the engine start/stop button
position on or ignition switch posi-
tion on, switch on the compressor
and let it run for approximately 5 ~
7 minutes to fill the sealant up to
proper pressure. (refer to the Tire
and Wheels, chapter 9). The infla-
tion pressure of the tire after filling
is unimportant and
checked/corrected later. Be careful
not to overinflate the tire and stay
away from the tire when filling it.
7 24
WARNING
Do not attempt to drive your
vehicle if the tire pressure is
below 200 kPa (29 psi). This
could result in an accident due
to sudden tire failure.
9. Switch off the compressor.
10. Detach the hoses from the
sealant bottle connector and
ODE066008L
from the tire valve.
Return the Tire Mobility Kit to its stor-
age location in the vehicle.
WARNING
Carbon monoxide poisoning
and suffocation is possible if
the engine is left running in a
poorly ventilated or unventilat-
ed location (such as inside a
building).
will be

Distributing the sealant

- Tire pressure
11. Immediately drive approximately
7 ~ 10 km or, about 10 min (4 ~ 6
miles) to evenly distribute the
- Carbon
sealant in the tire.
monoxide
Do not exceed a speed of 80 km/h
(50 mph). If possible, do not fall
below a speed of 20 km/h (12 mph).
While driving, if you experience any
unusual vibration, ride disturbance or
noise, reduce your speed and drive
with caution until you can safely pull
off of the side of the road.
ODE066040N