Mitsubishi Electric MR-LX630EM Operating Instructions Manual page 26

Troubleshooting
Problem
There are lines
like scratches on
the clear parts
There are holes
in the door and
the refrigerator
walls
The surface of
the sides or
doors is warped
Noise interferes
with televisions
or other devices
There is a
bothersome
smell (Food / Ice)
26
(Continued)
Check
Is it a thin line without level difference on
1
1
its both sides?
Are there small holes in the door or in the
1
refrigerator walls?
Does the light reflected on the surface
1
appear distorted?
Is the refrigerator installed near an
1
electronic device such as a television?
Is the power to the refrigerator supplied
2
from a socket near the entry hole of the
antenna cable?
Have you placed food with strong odor
1
inside the refrigerator without sealing it
in a container?
Do you periodically clean the water tank?
2
Explanation and Action
This is a mark created at the time the plastic is molded. It is
created at the joint where resin flows. This is not a flaw.
These are holes that let air escape for the injection of foam
heat insulating materials in the manufacturing process.
These are not flaws or abnormalities.
Warping and surface waviness occurs in the manufacturing
process. When light hits the surface, it may appear warped,
but this is not an abnormality.
Install the refrigerator away from electronic devices such as
televisions.
Use separate power. When using a 2 pin plug, use
grounding.
Store food with strong odor in packaging.
The odor may not be removed with a deodorizing apparatus.
Clean periodically.