Table of Contents
Advertisement
Quick Links
Model: 540491
Reverse Osmosis Tank Add-on Kit
Installation, Operation & Maintenance Guide
WARNING: Please read carefully before proceeding with
installation. Your failure to follow any attached instructions and
operating parameters may lead to the product's failure.
Thank you for purchasing an Aquatic Life Reverse Osmosis Tank Add-on Kit.
When maintained properly, this unit will provide you with years of quality filtered water.
OVERVIEW
Reverse Osmosis (RO) water is a process of removing
contaminants from tap water using a special semipermeable
membrane.
The process works quite slowly, so it is often desired to collect
the water in a storage tank so that the water is available on
demand when needed.
This Kit includes everything needed to add drinking water to
most existing RO Filtration Units.
1
SCAN CODE TO VIEW
INSTALLATION VIDEO
Contents (Model #540491)
Under Sink Water Line Adapter Valve
1
(½" Female x ½" Male x ¼" Press Fit)
1
Pressure Sensitive Solenoid
1
Chrome Faucet
1
In-line Check Valve
1
Drain Saddle
2
¼" Press-Fit Tees
1
Pressure Tank Valve
1
Water Storage Tank
1
¼" Manual On/Off Valve
Tools & Materials Recommended for Installation
1 ¼" Adjustable Wrench
7/16" Open End Wrench
1/8", 1/4", 1/2" Drill Bits for metal
(for faucet hole and drain hole)
Phillips Screwdriver
1
Polishing Carbon Cartridge
2
Carbon Cartridge Clips
2
¼" MPT x ¼" Press Fit Adapters
1
Set Mounting Screws
1
Roll Plumbers Tape
1
Yellow Tubing ¼" x 4 Ft
1
Blue Tubing ¼" x 4 Ft
Installation, Operation and
1
Maintenance Guide
Electric Drill
Masking Tape & Pencil
Flashlight
www.aquaticlife.com
Advertisement
Table of Contents
Related Manuals for AquaticLife 540491
Summary of Contents for AquaticLife 540491
- Page 1 When maintained properly, this unit will provide you with years of quality filtered water. SCAN CODE TO VIEW INSTALLATION VIDEO Contents (Model #540491) Under Sink Water Line Adapter Valve Polishing Carbon Cartridge (½” Female x ½” Male x ¼” Press Fit)
-
Page 2: Plumbing Diagram
Model: 540491 Reverse Osmosis Tank Add-on Kit Installation, Operation & Maintenance Guide OPERATING GUIDELINES DO NOT use with water that is micro-biologically unsafe or of unknown quality without adequate disinfection before the unit. Refer to your Reverse Osmosis Filtration Unit instructions for specific operating parameters. -
Page 3: Water Supply Installation
Model: 540491 Reverse Osmosis Tank Add-on Kit Installation, Operation & Maintenance Guide WATER SUPPLY DRAIN SADDLE INSTALLATION (cont.) INSTALLATION Step 3 – The Drain Saddle must be mounted at least 2” above the nut of the P-trap or cross bar from the garbage disposal to insure Connect the Under Sink Water Line proper drainage. -
Page 4: Faucet Installation
Model: 540491 Reverse Osmosis Tank Add-on Kit Installation, Operation & Maintenance Guide FAUCET INSTALLATION The faucet may be installed on any flat surface. Always check the underside of the desired location to make sure it is clear of interference. NOTE: Most sinks are pre-drilled with a 1 ¼” diameter hole that can be used for the faucet. - Page 5 Model: 540491 Reverse Osmosis Tank Add-on Kit Installation, Operation & Maintenance Guide POLISHING CARTRIDGE INSTALLATION HOW TO USE THE BUDDIE FIT™ PRESS FITTINGS The Polishing Cartridge contains carbon that will offer a finished To make easy ¼” tubing connections with the included Buddie Fit™...
- Page 6 Model: 540491 Reverse Osmosis Tank Add-on Kit Installation, Operation & Maintenance Guide INSTALLING THE TUBING & VALVES INSTALLING THE TUBING & VALVES (cont.) Step 5 – Install a piece of blue tubing between the “OUT” port Tubing is included with the kit. Yellow tubing is for supply water and Blue tubing is for filtered water.
-
Page 7: Unit Maintenance
Model: 540491 Reverse Osmosis Tank Add-on Kit Installation, Operation & Maintenance Guide UNIT MAINTENANCE CONNECTING A REFRIGERATOR OR ADDITIONAL FILTRATION Every Six Months In some instances, it may be desirable to add additional dispensers or further filtration to utilize the filtered water in the Storage Tank. -
Page 8: Product Registration
U.S. Mail: Lifetime Products, LLC, 9710 Klingerman St., S. El Monte, CA 91733 or electronic mail: customersupport@aquaticlife.com. Lifetime Products shall be allowed a reasonable period of time to investigate any warranty claim and to perform any testing Lifetime Products deems necessary to determine the cause of the defect.