Download Print this page

Elinchrom digital 1500 AS Instructions For Use Manual

110v and 230v

Advertisement

Quick Links

elinca sa switzerland www.elinchrom.com
POWER
POWER
POWER
POWER
POWER
STABILITY
STABILITY
STABILITY
STABILITY
STABILITY
UNIVERSALITY
UNIVERSALITY
UNIVERSALITY
UNIVERSALITY
UNIVERSALITY
TOTAL
TOTAL
ASYMMETRY
ASYMMETRY
TOTAL
TOTAL
TOTAL ASYMMETRY
ASYMMETRY
ASYMMETRY
Digital 1500 AS
For DIGITAL PHOTOGRAPHY
For DIGITAL PHOTOGRAPHY
For DIGITAL PHOTOGRAPHY
For DIGITAL PHOTOGRAPHY
For DIGITAL PHOTOGRAPHY
Instructions for use
Instructions for use
Instructions for use
Instructions for use
Instructions for use
110V and 230V, Version
English

Advertisement

loading

Summary of Contents for Elinchrom digital 1500 AS

  • Page 1 Digital 1500 AS elinca sa switzerland www.elinchrom.com For DIGITAL PHOTOGRAPHY For DIGITAL PHOTOGRAPHY For DIGITAL PHOTOGRAPHY For DIGITAL PHOTOGRAPHY For DIGITAL PHOTOGRAPHY POWER POWER POWER POWER POWER STABILITY STABILITY STABILITY STABILITY STABILITY UNIVERSALITY UNIVERSALITY UNIVERSALITY UNIVERSALITY UNIVERSALITY TOTAL TOTAL ASYMMETRY...
  • Page 2 Table of contents Table of contents Table of contents Table of contents Table of contents page Safety notice 3 3 3 3 3 Control panel 4 4 4 4 4 Before you start 5 5 5 5 5 Technical data 6 6 6 6 6 Mains inlet and fuses 7 7 7 7 7...
  • Page 3 The Elinchrom Digital 1500 As generator is manufactured by Elinca S.A. CH -1020 Renens/Switzerland Dear Photographer, Thank you for buying your «Digital 1500 AS» flash generator. All Elinchrom products are manufactured using the most advanced technology. Carefully selected component are used to ensure the highest quality and the equipment is submitted to many controls both during and after manufacture.
  • Page 4 7. Sync.-socket with security lock 21. Socket accessories 8. Open flash with charge indicator 22. Lamphead on/off 9. IR-Remote On/off FOR YOUR SAFETY, NEVER OPEN YOUR POWER PACKS OR YOUR LAMPHEADS. FOR REPAIRS, BRING THEM TO YOUR ELINCHROM AGENT..
  • Page 5: Operating Instructions

    Operating instructions Mains connection The unit is manufactured to run on 200-240 V, 50/60 Hz. Before connecting them for the first time, make sure that your mains supply and the rating set on the equipment (electrical specification plate) are compatible. Check that the mains switch (4) is OFF Insert mains cable to the MAINS INLET (1) and connect to a FULLY EARTHED OUTLET Using the mains switch (4) and switch the unit ON (switch illuminated)
  • Page 6 TECHNICAL DATA : This power pack Digital 1500 AS (1500Ws) offers three asymmetrical power head outlets. The power levels are indicated in Ws by bright LED display. These displays may be individually varied in 1/10th f-stop to any one of 57 settings on each lamphead (with three lampheads).
  • Page 7 Depress and turn the fuse holder anti-clockwise 1/8th and remove it. If the new fuse blows immediately upon reconnection return the pack to an ELINCHROM service centre for a check-up. (N.B. Check correct value of the fuse : 16 AT).
  • Page 8 If the green light does not appear the charge system could by defective. Please contact and send to an authorized Elinchrom service . N.B. Situation 2, as above is the only time when the open flash will function while the indicator blinks.
  • Page 9 8. TOTAL POWER This display indicates the total power released through the lampheads. The variation is a single steps or if the touch is held it will run continuously. The first number indicates charges by full f-stop, the second number by 1/10 f-stop. When the total power is increased each individual lamphead increases proportionately.
  • Page 10 The Amphenol secure locking system with standard 5 m cable is retained. Longer cables may be used. N.B. Do not link ELINCHROM units by cable to other manufacturers sync outlets. ELINCHROM uses low voltage (12 V) for security reasons and other systems with higher voltages may cause damage. 12. ACCESSORY SOCKET...
  • Page 11 14. MODELLING LAMP CONTROLS The modelling lamp will only function when the lamphead is switched on (note : there is an overheating control switch ON/OFF in the lamphead). - Simple ON/OFF with ON setting indicated. Also incorporated is a slow start system to prolong lamp life - Half power lamp setting further extends lamp life - Adjusts the lamp to vary with the flash power.
  • Page 12 USE OF IRS The indicator on the IRS will «blink» on the generator when its channel has not been selected. However, selecting its channel «O» will re-activate the units response system. The units function like and are therefore totally compatible with Micro AS power packs and 750 Micro. 2 2 2 2 2 13.
  • Page 13 They can be used for standard or action : a) with each cable in a separate power pack, it gives standard flash duration. b) with both cables in the same power pack, it gives short flash duration. FOR YOUR SAFETY, USE ONLY ELINCHROM LAMPHEADS ON YOUR GENERATORS...
  • Page 14 18. LAMPHEAD COMPATIBILITY Below is a table listing lampheads made since 1980 which are adaptable and indicates the equivalent in the current series. MAXIMUM Compatible with : Digital 1500/3000 AS and MICRO AS ADAPTABLE POWER From 1992 1988 1986 1980 1500/2400 WS S1500 N S 2000...
  • Page 15 Accessories overview Accessories overview Accessories overview Accessories overview Accessories overview Spots Spots Spots Spots Spots code code code code code Reflectors Reflectors Reflectors Reflectors Reflectors code code code code code Zoom 12° - 24° 26471 Wide angle ø 16 cm /90° 26143 Compact ø...
  • Page 16 Visit our Web site : www.elinchrom.com Elinca s.a E. Digital 1500 AS (73315) Printed in Switzerland...