Planar PD7170 Installation And Operation Manual page 62

Operation
Source Select: To select a video source, press or to highlight Source Select,
then press ENTER. This displays the Source Select sub-menu, shown in Figure 4-7.
The default source selection is HDMI 1. All sources that are not available per the
source enable function (refer to Source Enable on page 56) are grayed out.
Figure 4-7. Source Select Sub-Menu
PIP Select: To select a PIP (secondary) video source, press or to highlight
PIP Select, then press ENTER. The default PIP selection is Off.
All sources that are not available per the source enable function (refer to
Source Enable on page 56) are grayed out.
All sources that cannot be used for PIP due to a shared electronic path with the
Active source are grayed out. The PIP source is a saved setting for each source,
like brightness and contrast.
If for some reason the current PIP source becomes invalid (by disabling it in the
source enable menu, for instance), PIP Select automatically resets to Off.
Resync: If the projected image becomes unstable or degraded, press or
to highlight Resync, then press ENTER. This causes a re-acquisition of the active
source and the PIP source, if present. It also changes any Fine Sync settings
(described on page 53) for this timing to the default setting.
48 Planar PD7170 Installation/Operation Manual