Planar PD7170 Installation And Operation Manual page 57

Memory: Select Memory from the Main menu, then press ENTER to recall image
quality settings previously saved, or to save changed settings in any of four
memory locations.
• Recall Memory: Select Recall Memory from the Memory menu to recall
saved image quality settings. Unless you select Default (see below), this
control affects all sources, not just the active source.
• User Memory 1 and User Memory 2 contain the factory default settings
when the projector is initially turned on.
• When you recall the ISF Day or ISF Night memory settings, all settings
associated with these stored values are grayed out. This prevents
unintended adjustments from being made. To remove this restriction,
choose User Memory 1 or User Memory 2.
ISF Day and ISF Night are grayed out unless these custom settings have
already been saved.
• Choose Default to restore the factory-default settings for the active source
only. The other sources are unaffected.
• Save Settings: Select Save Settings from the Memory menu to save any
image-related settings you have changed to User Memory 1 or User
Memory 2.
The following items are saved (for all sources, not just the active source):
• Brightness / Contrast
• Color Saturation / Color Tint
• Sharpness (all settings in sub-menu)
• Noise Reduction (all settings in sub-menu)
• Color Space
• Video Standard
• Gamma
• Color Temperature
• DLP Frame Rate
• Color Gamut
• DynamicBlack
• Adaptive Contrast
• RGB Adjust (all settings in sub-menu)
• Lamp Power
• Save ISF: Select Save ISF from the Memory menu to save any image-related
settings you have changed to the ISF Day or ISF Night memory location.
You must enter a passcode to access the Save ISF
Note
sub-menu.
The settings that are saved are the same as those saved with the Save
Settings command (see above).
Planar PD7170 Installation/Operation Manual 43
Operation