Using The Styler - LG S3RERB Owner's Manual

20 OPERATION

USING THE STYLER

1 PREPARE ITEMS
2 CLEAN LINT FILTER, CHANGE SHEET IN AROMA FILTER
3 CHECK WATER TANKS
4 LOAD STYLER
5 TURN ON STYLER
6 SELECT CYCLE
7 BEGIN CYCLE
8 END OF CYCLE
• Wash clothes first, if needed.
• No heat-sensitive items or items that can be damaged by exposure
to water. See Choosing Styler-Safe Clothing, page 21.
• Place items on hangers or the shelf.
• Fasten buttons and close zippers to keep items on moving hangers
and prevent damage.
Lift out filter and remove lint from last load for faster and more efficient
performance. Reinstall filter, checking alignment when closing grill. Do not
operate the Styler without the lint filter in place. See Checking the Lint
Filter, page 24. If using a fabric softener sheet in the aroma filter, change it
after every use. See Changing the Aroma Sheet, page 24.
Fill water supply tank if needed. Empty water drain tank if needed. Use
clean tap water in the supply tank for better product performance and
lifespan. Do not use distilled water or reuse water from the drain tank. See
Checking the Water Tanks, page 25.
Pay attention to fabric care labels and cycle choice. If clothing is
not appropriate for the cycle selected, it may shrink or be seriously
damaged. See Loading the Styler, page 25.
Remove all empty hangers to avoid noise, friction, and damage to clothing.
Touch POWER to turn on the Styler.
Touch icons to select desired cycle and settings. See the Cycle Guide,
page 32.
Touch and hold START/PAUSE to begin cycle. Pause cycle at any time by
touching START/PAUSE again. Restart cycle within four minutes of pausing
it, or the Styler shuts off and settings are lost. Do not open door during cycle.
If steam or hot air escape from open door, condensation may collect on floor
or walls, resulting in damage or mold.
Remove items when cycle finishes. Leave door open to let hot air escape.
Interior light shuts off after 4 minutes if door is left open.