Table of Contents
Advertisement
Product Use
Operating in 2D mode
Your SD2020 unit can operate
either as a 3D stereoscopic
monitor or in the standard 2D
mode. There are two options to
convert to 2D:
• Simply turn off the power to
one monitor.
• Lift the mirror and slide it
into the locked, upright
position.
To return to 3D/stereo, simply
reverse the procedure.
User controls and OSD menu
The two monitors have a soft DC power switch near the center of the bottom
bezel. This control is used for turning the monitor on or off. To the right of
the power switch is an LED
power indicator. When the LED
is green, the power is on. A
yellow light indicates that the
monitor is in power-saving
mode. The left and right
Function Select buttons [Fn]
can be used to control the
On-Screen Display (OSD) menu
selection. The left and right
Adjustment Control buttons [+/-] can be used to increase or
decrease the OSD setting, respectively.
The two monitors have an OSD menu that allows control of the brightness,
contrast, and color settings. Adjustment of the brightness setting is not a
direct increase or decrease to the overall luminance, but a driving voltage
adjustment of the LCD panel. In other words, setting the brightness to
0 (zero) does not reduce the luminance to 0 cd/m
NOTE: Changing the Brightness setting can reduce the number of discernable
gray levels.
SD2020
StereoMirror in 2D mode.
Controls and LED indicator.
2
.
| 9 |
User's Guide
Advertisement
Table of Contents
