Page 2
DESCRIPTION 1. Chuck 7. Magnetic holder 2. Torque control 8. Battery clip 3. High/low speed control 9. Battery pack 4. Forward/reverse switch 10. Drill bits x 6 5. LED light 11. Screw driver bits x 6 6. Trigger switch 12. Magnetic bit holder...
Page 3
DESCRIPTION Fig. 2 Important! It is essential that you read the instructions in this manual before operating this machine. Subject to technical modifications Please refer to pages 3 - 5 for instructions...
Page 4
Children should be supervised to ensure that GENERAL POWER TOOL SAFETY WARNINGS medication. A moment of inattention while GENERAL POWER TOOL SAFETY WARNINGS operating power tools may result in serious they do not play with the appliance. Maintain power tools. Check for personal injury.
CHARGING YOUR BATTERY PACK Voltage Refer to “CHARGING A COOL BATTERY PACK” battery pack and charger to your nearest Ryobi The battery pack for your tool has been shipped in No load speed 0-400/1200 min for normal recharging of batteries.
WARNING WARNING into the chuck jaws at an angle then tighten, (FORWARD/REVERSE/CENTER LOCK) When servicing, use only identical Ryobi as shown in figure 5. This could cause the Be prepared for binding at the bit See Figure 3. replacement parts. Use of any other parts breakthrough.