Advertisement
ENG
Network Load Controller
Attention! Do not overload АNLС's sockets - it can lead to the out of order of the device.
Power consumption of devices connected to АNLС's every socket must not exceed 3.6 kW.
5. TROUBLESHOOTING
Problem
Automatic network load
controller is not turned on.
АNLС is on, but voltage is absent
in sockets.
Excess heating of the device,
sparkling, burning odor.
If none of the above methods can solve the problem, please seek professional advice at your
nearest service center. Never attempt to repair the product by yourself.
6. TECHNICAL SPECIFICATIONS
Parameter
Rated voltage, V
Maximum load current for every socket, А
Maximum power for every socket, kW
Operation threshold according to power consumption, W
Turn-on delay time of the secondary load, sec
Turn-off time of the secondary load, sec
Dimensions, mm
Weight, g
Notes:
• Technical specifications given in this table are supplemental information and cannot give
occasion to claims.
• Technical specifications and package contents are subject to change without notice due
to the improvement of TM REAL-EL production.
4
Technical support: www.real-el.com
Cause
No voltage in the power
supply network.
АNLС is out of order.
АNLС is out of order.
AR-01
Solution
Make sure that voltage is
available.
Address to a service-center.
Disconnect АNLС from the mains
socket and address to a
service-center.
Value
~230
16
3.6
100
not less than 2
not less than 0.3
94 × 80 × 81
130
Advertisement
