Toro TimeCutter HD XS4850 Operator's Manual page 25

2. Move the motion-control levers outward to the
N -L position, engage the parking brake,
EUTRAL OCK
shut off the engine, remove the key, and wait for all
moving parts to stop before leaving the operating
position.
3. Remove the mower deck; refer to
Deck (page 47).
4. Remove the 2 locknuts (5/16 inch) secured to the
welded posts of the left baffle on the top of the mower
deck at the center and left of center positions
30).
4
3
Figure 30
1. Locknut (5/16 inch)
2. Carriage bolt (5/16 x 3/4
inch)
5. Remove the carriage bolt and locknut on the side wall
of the mower deck securing the left baffle to the deck.
6. Remove the left baffle from the mower deck as shown
in Figure 30.
7. Remove the 2 carriage bolts (5/16 x 3/4 inch) and
2 locknuts (5/16 inch) securing the assembled right
baffle and baffle guard to the mower deck
Figure 31
1. Carriage bolt (5/16 x 3/4
inch)
2. Locknut (5/16 inch)
Removing the Mower
(Figure
1
2
G011149
3. Left baffle
4. Install the fasteners here.
(Figure 31).
3. Right baffle
4. Baffle guard
8. Remove the 2 locknuts (5/16 inch) to securing the
welded posts of the right baffle to the top of the
mower deck at the center and right of center positions
(Figure 32).
Note: Remove the right baffle from the mower deck.
1
2
1. Locknut (5/16 inch)
g011149
2. Right baffle
9. Locate the cutoff baffle in the loose parts bag and
remove the fasteners at the rear holes of the discharge
plate (Figure
1. Carriage bolts (existing)
g191136
2. Rear holes in the
discharge plate
10. Install the baffle at the side discharge opening on the
mower deck.
25
3
Figure 32
3. Welded posts (right baffle)
33).
Figure 33
3. Cutoff baffle (loose)
4. Locknuts (existing)
1
G010704
g010704
g190734