Sony PCV-J200 Service Manual page 23

1.2.7 Line Out(Headphone)/Line In/Microphone Jack
Connector location on MB Rear side, see the frame harness diagram
Line Out pin assignments :
Pin Signal Name
Sleeve Ground
Tip Audio Left Out
Ring Audio Right Out
Line In pin assignments :
Pin Signal Name
Sleeve Ground
Tip Audio Left In
Ring Audio Right In
Microphone In pin assignments :
Pin Signal Name
Sleeve Ground
Tip Microphone mono In
Ring Electret Bias Voltage
1.3 Jumper Header
1.3.1 CMOS Clear
Clear the RTC data
Connector location on MB See the frame harness diagram
Jumper header
2 3
1
combination of jumper caps :
CMOSCLR
Clear 2-3
Normal * 1-2
* is default setting
1.3.2 VGA IRQ
Set VGA TRQ
Connector location on MB See the frame harness diagram
Jumper header
2
1 3
Combination of jumper caps
VIRQ
Disable 1-2
Enable* 2-3
* Is default setting
1.3.3 Secondary DASP (Only for Rev. 1.07 M/B)
Secondary DASP Enable/Disable
Connector location on MB See the frame harness diagram
Jumper header
2
1
Combination of jumper caps
J0801
Disable Open
Enable Closed
US Model: Open
JP Model: Closed
6-3
Confidential
PCV-J200 (UC)