Pioneer VSX-516-S/-K Operating Instructions Manual page 51

Additional information
Problem
No sound from surround or
center speakers.
No sound from surround back
speaker (VSX-516 model only).
No sound from subwoofer.
Noise during playback of a
cassette deck.
No sound is output or a noise
is output when software with
DTS is played back.
During a playback search,
noise is output from a DTS
compatible CD player.
Can't operate the remote
control.
The display is dark or off.
Remedy
• Connect the speakers properly (refer to page 17).
• Refer to Speaker setting on page 38 to check the speaker settings.
• Refer to Channel level on page 39 to check the speaker levels.
• Refer to Speaker setting on page 38 to check the surround back
speaker settings.
• Refer to Channel level on page 39 to check the speaker levels.
• Refer to Using surround back channel processing on page 31 to
make sure surround back channel processing and the sound mode
are set for surround back sound.
• Make sure the subwoofer is switched on.
• If the subwoofer has a volume knob, make sure it's turned up.
• The Dolby Digital or DTS source you are listening to may not have
an LFE channel.
• Switch the subwoofer setting in Speaker setting on page 38 to YES
or PLUS.
• Switch the LFE Attenuator Setup on page 40 to
10
.
• Move the cassette deck further from your receiver, until the noise
disappears.
• Set the digital volume level of the player to full, or to the neutral
position.
• This is not a malfunction, but be sure to turn the volume down to
prevent the output of loud noise from your speakers.
• Replace the batteries (refer to page 5).
• Operate within 7 m, 30° of the remote sensor on the front panel
(refer to page 5).
• Remove the obstacle or operate from another position.
• Avoid exposing the remote sensor on the front panel to direct light.
• Press DIMMER on the remote repeatedly to return to the default.
LFEATT 0 LFEATT
or
11
51
En