Summary of Contents for Beta Marine D Panel
- Page 1 Operators Operators Maintenance Maintenance Manual Manual Control Panel D - Digital Control Panel D - Digital...
- Page 2 CONTROL PANEL ‘D’ - DIGITAL Is our most technically advanced engine control/monitor The panel uses standard Micro-C connection which allows whose module is water resistant to IP67 and has a super data to be relayed and viewed all across your on-board bright screen that facilitates viewing in both strong network.
-
Page 3: Panel Layout
PANEL LAYOUT Digital Power Switch For Display Only Dashboard Display Push Buttons Control Button For Engine Control (Functionality retained even when display is powered off) OPERATING THE ENGINE STARTING STOPPING 1. Switch the panel on via the ‘POWER switch. 1. Press the ‘STOP’ button until the engine stops. This should not be more than 5 seconds. -
Page 4: Using The Display
USING THE DISPLAY Along the bottom of the display there are 5 display control buttons. DISPLAY BUTTON FUNCTIONALITY: This button displays general over view of engine This button displays a bar graph version of all speed, oil pressure, water temp and alarms. Pressing readable values. -
Page 5: Config Menu
DISPLAY SCREEN ADJUSTMENT MENU DISPLAY BUTTON FUNCTIONALITY: Decreases display brightness. Increases display brightness. Decreases display contrast. Increases display contrast. Saves settings and exits menu. CONFIG MENU DEMO ON/OFF When highlighted in a yellow bar the sales demonstration mode can be switched on or off by pressing button If no further functionality changes are required, pressing button again saves settings and exits the CONFIG... - Page 6 BLEEP ON/OFF When highlighted as a yellow bar you can turn the key sound on or off by pressing button . If no further functionality changes are required pressing button saves settings and exits the SETTINGS menu. Press button to scroll down the screen to highlight - RPM Calibrate When highlighted as a yellow bar enter this option by pressing button...
- Page 7 Single engine or Port engine When highlighted as a yellow bar, pressing button allows you to switch identity from Single engine or Port Engine to Starboard engine identification. On a twin engine vessel with an on-board network it is important to set one engine as Single or Port and the other as Starboard to ensure all correct data and views are available within on-board network devices.
- Page 8 Alarm Thresholds Panel D has Beta Marine recommended Alarm Threshold values set as default. Depending on the vessel, application and its use it may be appropriate to raise or lower these values. Note: This should not be done without consulting Beta Marine for technical advice/approval.
- Page 9 RESTORE DEFAULTS This function resets the D Panel to factory default settings, engine hours and any custom configuration will be lost. Note: If used it will necessary to recalibrate engine RPM and re-enter any previous custom configuration previously stored. When highlighted by a yellow bar press button...
- Page 10 RPM Calibration Chart This chart has produced with standard pulley ratios at the time of printing. If you are unsure of any information provided or for further information please contact Beta Marine. Date produced: 18-03-15 rev 00. Kubota Alternator &...
- Page 11 USB stick is used that only connection extension lead available. Depending on cable has the required two Beta Marine files within and contains flexibility it may have to be supported with an appropriate no other data.
- Page 12 5. Replace the rubber grommet/bung into the D panel. (Fig 2 & Fig 3). 6. Refit D panel into the vessels installation point. Once engine battery is reconnected and display panel is switched on, you must reset the RPM calibration and engine hour meter.
- Page 16 Beta Marine Limited, Davy Way, Waterwells, Quedgeley, Gloucester, GL2 2AD. UK. Tel: +44 (0)1452 723492 Fax: +44 (0)1452 883742 Email: sales@betamarine.co.uk Website: www.betamarine.co.uk Ref: OM 221-10643 REV 01...