Displays & Controls; Front Panel - Pioneer VSX-409RDS Operating Instructions Manual

Displays & Controls

Front Panel

1 2 3 4 5 6 7 8 9
@
1 MAIN POWER button
Push to send electricity to the receiver. Note the
STANDBY/ON button below actually turns the
receiver on and standby.
2 STANDBY indicator
Lights when the receiver is in standby mode
(note that the receiver consumes a small amount
of power (1W) in standby mode).
3
STANDBY/ON button
Switches the receiver between on and standby.
4 STATION (+/–), FREQUENCY (+/–),
TUNING SELECT buttons (see p. 23–27)
STATION (+/–)
Selects station memories when using the tuner.
FREQUENCY (+/–)
Selects the frequency when using the tuner.
TUNING SELECT
Switches between station memory and
frequency select modes.
5 CLASS button (see p. 25-27)
Switches between the three banks (classes) of
station memories.
6 MEMORY button (see p. 25, 26, 29, 30)
Press to memorize a station for recall using the
STATION (+/–) buttons. Also use to search in
RDS mode
7 RF ATT button (see p. 23)
Use to lower the input level of a radio signal that
is too powerful or has interfering waves, thus
causing the receiver to distort
8 CHARACTER/SEARCH button(see
p.30)
Use this button to search for different program
types in RDS mode. It is also used to input
station names.
9 EON MODE button (see p. 31)
Use this button to search for different programs
that are transmitting traffic or news information
(this search method is called EON).
0 Display (see p. 18)
0
# $ %
- Remote sensor
= DSP MODE button (see p. 22)
~ DOLBY PRO LOGIC button (see p. 20)
! MASTER VOLUME
@ PHONES jack
# SPEAKERS button
$ FL DIMMER button
% BASS (+/–) buttons
^ TREBLE (+/–) buttons
& Function buttons
* S.BASS button
( DIRECT button
- = ~
^ & * (
Receives the signals fromthe remote control.
Use to switch between the various DSP modes
available (HALL, JAZZ, DANCE, THEATER1,
THEATER2) and DSP off. Use to create different
surround sound effects from any stereo source.
Use to switch between the various Pro Logic
modes (PRO LOGIC, PRO LOGIC THEATER1,
PRO LOGIC THEATER2) and Pro Logic off.
Use to set the overall listening volume.
Connect headphones for private listening .
Use to switch the speaker system on or off.
Use this button to make the fluorescent display
(FL) dimmer or brighter. There are three
brightness settings as well as an off setting.
Use to increase/decrease bass (within a range of
– 6dB to 6dB in 2dB steps). It cannot be used
when S.BASS is on.
Use to increase/decrease treble (within a range
of – 6dB to 6 dB in 2dB steps).
Use to select a source for playback or recording.
Use to switch on and off the bass boost. Use for
a more powerful bass sound. Negates use of
BASS buttons.
Use to switch DIRECT playback on or off. This
mode bypasses all tone controls, Dolby, DSP and
channel levels for the most accurate
reproduction of a program source.
!
17