Advertisement
........................................................................................................................................2
Panel.................................................................................................................................2
..........................................................................................................................3
User Manual
.....................................................................................................4
Camera...............................................................................7
..................................................................................................7
Camera.............................................................................................7
1
Advertisement
Table of Contents
Related Manuals for Xirlink X9901
Summary of Contents for Xirlink X9901
-
Page 1: Table Of Contents
User Manual Battery ............................2 Status Panel..........................2 Taking a Picture ..........................3 Viewing / Modifying Pictures .....................4 Erase The Pictures Stored Inside the Camera................7 Using the Album Application ....................7 Using the Buttons on the Camera.....................7... -
Page 3: Battery
Battery Insert one battery into the compartment as shown Status Panel Display the abbreviated messages and the counts of picture taken List of LCD display messages – case sensitive 1. Po: picture overflow cause: compressed picture size over the SRAM size (it won't happen in this camera) reseult: system soft-reset 2. -
Page 4: Taking A Picture
6. Lo: battery low cause: battery voltage below the threshold result: may cause picture worse quality (try new battery) 7. LL: low light condition cause: no enough lighting result: longer exposure time and may have noise within the picture 8. --: enter testing mode cause: press both buttons while power up result: start testing routine after release both buttons 9: FO: verify flash OK... -
Page 5: Viewing / Modifying Pictures
4. Press the self-timer button to take a picture of yourself. Note: You will hear the beeps in an increasing frequency manner from the Camera Microphone. Viewing / Modifying Pictures 1. Connect the serial port from the camera to the computer... - Page 6 2. Open the DPS320 ALBUM application from the Start Program menu...
- Page 7 3. Click on the Download button while the camera is powered on and connected 4. Double click on an icon to open the picture for viewing or modification...
-
Page 8: Erase The Pictures Stored Inside The Camera
Erase The Pictures Stored Inside the Camera Using the Album Application Click on the Erase button while the camera is powered on and connected Using the Buttons on the Camera 1. Press and hold the two buttons while the camera power is on... - Page 9 2. Switch the power to Off and then back On twice while you are holding the buttons Note: After erasing the memory inside the camera (using either one of the techniques described above), the LCD display on the Status Panel should read “00”.
Need help?
Do you have a question about the X9901 and is the answer not in the manual?
Questions and answers