Speaker Terminals - Sony KX-1901 Operating Instructions Manual

•
MULTI INPUT connector (8-pin DIN)
Connect to the MULTI OUTPUT (8-pin DIN) connector on a Sony
Component TV tuner with the VK-2D Video Cable (supplied with the
tuner, 2 m) . The audio, video and control signals can be connected
simultaneously with this cable.
The volume and picture can be adjusted and the power can be turn-
ed on or off using the controls on the TV tuner or the Remote Com-
mander (supplied with the tuner).
Engage this projecti on w ith this slot.
To disconnect , push
this button.
VK-2D
The VK-5DX Video Cable is available optionally for extending the
VK-2D.
Caution: Use either the VIDEO/AUDIO/CONTROL Cl)
4D
41) jacks
or the MULTI INPUT connector, but not both simultaneously.
G) SPEAKER terminals
Connect to an 8-16 ohms speaker system .
Speaker cord connections
Remove the
covering.
10
15 mm
~
Twist th e wire ends .
f
While pushing the button, insert
the w ire, th en release the button.
Pull lightl y on the connection to
make sure it is secure.
Caution
• Make sure that none of the strands are separated from the wire
and shorts across the speaker terminals .
• Correct
Ee 8
connection of both speakers insures proper in-
phase operation . If the speaker system is out-of-phase, the bass
tones seem to be missing and the position of the instruments
becomes obscure.
• The set should be placed some distance away from the speakers
so that it will not be affected by the speaker magnets.
If a temporary proximity to magnets should cause portions of the
picture to have poor color, turn the POWER button off, and after
about 10 minutes, turn it on .
The Sony SS-X1A and SS-X10A Speaker System (optional) may be
placed near the set because these are a low magnetic flux leakage
type.
• Never connect a speaker system to an amplifier and this Compo-
nent TV simultaneously, as this may damage the TV.
speaker sys tem
amplifier
fj AC OUTLET (SWITCHED)
Component
TV
Provides ac power of 200 W max. (KX-2501) or 250 W max. (KX-1901)
to other connected equipment. Power can be switched on and off
with the POWER button on the Component TV.
Caution
• When the set is used with a Sony Component TV tuner, do not
connect the ac power cord of the tuner to this outlet. Otherwise , the
power cannot be turned on or off using the control on the tuner or
the Remote Commander (supplied with the tuner).
Component TV tuner
,--
to
I
AC OUTLET .
D
Component
TV
• Do not connect electrical home appliances such as an electric
iron, fans, or other high-wattage equipment to this outlet.