FA goods FA-TB32XYP3 User Manual page 3

[Wiring Precautions]
 Shut off the external power supply for the system in all phases before installation and wiring.
 After wiring, attach the included terminal cover to the module before turning it on for operation.
Failure to do so may result in electric shock.
[Wiring Precautions]
Use applicable solderless terminals and tighten them within the specified torque range. If any spade

solderless terminal is used, it may be disconnected when the terminal screw comes loose, resulting in
failure.
 Check the rated voltage and terminal layout before wiring to the module, and connect the cables
correctly. Connecting a power supply with a different voltage rating or incorrect wiring may cause a fire
or failure.
 Do not install the control lines or communication cables together with the main circuit lines or power
cables. Keep a distance of 100mm (3.94 inches) or more between them. Failure to do so may result in
malfunction due to noise.
 Place the cables in a duct or clamp them. If not, dangling cables may swing or inadvertently be pulled,
resulting in damage to the module or cables or malfunction due to poor connection.
 Tighten the terminal screw within the specified torque range.
Undertightening can cause short circuit, fire, or malfunction.
Overtightening can damage the screw and/or module, resulting in drop, short circuit, or malfunction.
 Tighten the connector screws within the specified torque range. Undertightening can cause short circuit,
fire, or malfunction. Overtightening can damage the screw and/or module, resulting in drop, short circuit,
fire, or malfunction.
 Install the connector to the module securely. Failure to do so may cause malfunction.
 When disconnecting the cable from the module, do not pull the cable by the cable part. For a cable with
connector, hold the connector by hand and pull it out. For a cable connected to a terminal block, loosen
the terminal block screws first before removing the cable. Failure to do so may result in malfunction and
damage to the module or cable.
 Before connecting the cables, check the type of interface to be connected. Connecting or erroneous
wiring to the wrong interface may cause failure to the module and external devices.
 Prevent foreign matter such as dust or wire chips from entering the module. Such foreign matter can
cause a fire, failure, or malfunction.
 This product must be installed to control panels. Connect the main power supply to this product in the
control panel through a relay terminal block. Wiring and replacement of a this product must be performed
by qualified service personnel who is familiar with protection against electric shock.
 When connecting programmable controller, check that the product configuration are correct. The
modules may be failure or malfunction if the configuration is incorrect.
 Use it with power doesn't join the connector of this product. Failure or disconnection may cause
malfunction.
WARNING
CAUTION
3