JVC RX-DP20VSL Service Manual page 17

3.3 Front panel assembly section
3.3.1 Removing the FL display board & front AV in board
(See Fig.1 and 2)
• Prior to performing the following procedure, remove the top
cover and front panel assembly.
(1) Pull out the volume knob on the front side of the front panel
assembly and remove the nut attaching the FL display
board.
(2) Remove the three screws A attaching the front AV in board
and remove the front AV in board.
(3) Remove the nine screws B attaching the FL display board
on the back of the front panel assembly.
(4) Disconnect the harness from the connector CN969,
and CN982 on the FL display board.
3.3.2 Removing the power switch board & front DIGITAL in board & motor assembly
(See Fig.3)
• Prior to performing the following procedure, remove the front
panel assembly and FL display board.
(1) Remove the four screws C attaching the power switch
board and remove the power switch board.
(2) Remove the screw D attaching the front DIGITAL in board
and remove the front DIGITAL in board.
(3) Remove the three screws E attaching the motor assembly
on the back of the front panel assembly.
(4) Remove the belt and the two screws a attaching the motor.
Operation switch panel
CN975
Door
A
Front AV in board
CN973
D
Front DIGITAL
in board
Front panel assembly
Volume knob
Fig.1
FL display board
B B
CN982
CN373
B
Fig.2
Power switch board
F F
CN373
Door
Belt
Motor assembly
Fig.3
Nut
CN969
CN975
C
E
a
(No.22019)1-17