Disassembly Method; Removing The Top Cover; Removing The Rear Panel - JVC RX-E112RSL Service Manual

Disassembly method

Removing the top cover

1. Remove the four screws A attaching the top cover on
both sides of the body.
2. Remove the three screws B on the back of the body.
3. Remove the top cover from behind in the direction of
the arrow while pulling both sides outward.
Removing the front panel assembly
Prior to performing the following procedure, remove
the top cover.
1. Cut off the tie band fixing the harness, if needed.
2. Disconnect the card wire from the connector CN411
on the audio board, CN412 on the input board and
CN204 on the power supply board.
3. Disconnect the harness form the connector CN209
on the power supply board.
4. Remove the three screws C
panel assembly.
5. Remove the screw D attaching the headphone jack
board.
6. Remove the four screws E attaching the front panel
assembly on the bottom of the body. Detach the front
panel assembly toward the front.

Removing the rear panel

Prior to performing the following procedure, remove
the top cover.
1. Remove the power cord stopper from the rear panel
by moving it in the direction of the arrow.
2. Remove the nineteen screws F & G attaching the
each boards to the rear panel.
3. Remove the four screws H attaching the rear panel
on the back of the body.
(See Fig.1)
(See Fig.2 and 3)
Audio board
attaching the front
(See Fig.4)
Top cover
A
(both sides)
Tie band
Main board
CN411
CN412
E
F
Rear panel
F
H
RX-E112RSL/RX-E111RSL
B
Fig.1
Front panel assembly
C C
CN209
D
(attaching the
headphone jack board)
CN204
Power supply
board
Input board
Fig.2
(Bottom side)
Front panel assembly
E
Fig.3
Power cord
stopper
F G
H H
Fig.4
H
1-3