1. Manuals
  2. Brands
  3. GeMNeXT Manuals
  4. Extender
  5. EXT-200-LAN
  6. User manual

GeMNeXT EXT-200-LAN User Manual

Up to 200m distance
Hide thumbs
1
2
3
4
5
6
7
8
9
Table of Contents

Advertisement

Quick Links

Download this manual
U S E R M A N U A L
HDMI Extender up to 200M Distance
EXT-200-LAN

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the EXT-200-LAN and is the answer not in the manual?

Questions and answers

Related Manuals for GeMNeXT EXT-200-LAN

Summary of Contents for GeMNeXT EXT-200-LAN

  • Page 1 U S E R M A N U A L HDMI Extender up to 200M Distance EXT-200-LAN...
  • Page 2 1.Introduction HDMI Over Ethernet is based on TCP/IP standard. It transmits your HD display with the high resolutions up to 120 meters away from your HDMI or DVI-D source by using one CAT5e/6 cable. With the advantage of TCP/IP standard，you can extend your HD video to multiple displays by using an Ethernet Switch.

  • Page 3: Specifications

    2.Specifications ➢ Following TCP/IP standard. ➢ Support HDMI1.3 protocol. ➢ HDCP1.1 & 1.2 protocol compliant ➢ Support point-to-point mode, one point-to-many mode and cascade connection mode. ➢ Support IR extender function allows IR remote control of Source devices from remote viewing location by sending IR commands received in the vicinity of the Display back to the Source devices.

  • Page 4: Panel Descriptions

    4.Panel Descriptions HDMI Transmitter 5V/1A Supply power for the Transmitter Reset Hold down the key for 5 seconds IR-out Connect IR transmitter this Port HDMI-in Connect HDMI sink source to this Port HDMI Receiver...

  • Page 5: Connection And Operation

    5V/1A Supply power for the Receiver Reset Hold down the key,the model will re-start IR-in Connect IR Receiver this Port HDMI-out Connect HDMI sink device to this Port 5.Connection and operation 1) Connect the HDMI source (such as DVD, PS3, STB ) to the HDMI IN of Sender. 2) Connect the IR sender to the Sender IR OUT Port, and Be Directed at HDMI video source’s IR receiver.
  • Page 6 Application 2 – Point To MultiPoint 6. IP settings – GUI When typing the IP address as found on the Transmitter or Receiver he Graphical User Interface is displayed. Connect the laptop or PC that is connected from the LAN port of the laptop or PC to the RJ45 port of the Transmitter or Receiver.

  • Page 7: Status Display

    6.1 Status Display In Status Display the Device status is shown with System Version and Rate Config (Input resolution and Output resolution. This is for Transmitter device or Receiver device. 6.2 System Config – Network config In Network config the device IP settings can be modified to bring all devices in the same range of your desired network.
  • Page 8 If a new system version is available in order to upgrade potential new or improved functionality this can be done by the System update button where a specific file can be uploaded. This would only be needed when communicated by GeMNeXT.
  • Page 9 6.5 Reset To reset the device it is needed to press the Reset button on the back of the device for 5 seconds. After this the device would be reset and this would automatically result in a changed IP address to a default IP address. Please note this default address is not the IP address described on the label on the device.

Table of Contents