Table of Contents
Advertisement
Additional Note for Windows NT4.0
The installation procedure under Windows NT4.0 will be a little different from
Windows 98 shown below. It will be change after step10 refer to the installation of
Windows 98.
2. Click " OK " and system will auto-select I/O address and IRQ and remind
you to choose the unused I/O address and IRQ from Windows NT
Diagnosis to prevent system resource conflict.
3. If the Ndis 3.0 packet driver has already existed in your system, the setup
message will be prompted as follows, just click " OK " .
4. A prompt of networking setting will appear as follows. It's the same as
Windows 98 operating system.
10
Advertisement
Table of Contents
