Assembly; Operation - Greenlee 690 Instruction Manual

Assembly

Refer to the "Illustration" and "Parts List" sections of
this manual.
1. Attach the handle to the tank by using four screws
(44) and four washers (43). Make sure to leave
enough space for the storage box. DO NOT screw
the screws tight.
2. Attach the storage box to the tank by position-
ing the box over the screws and washers from
the handle and sliding the box down firmly until it
locks into place. If preferred, tighten the screws
to squeeze the storage box. Be careful NOT to
overtighten.
Greenlee / A Textron Company
43
44
6
690 Power Fishing System
3. Attach the storage box lid to the handle by using
two shoulder screws (47) and two nuts (48).

Operation

• Wear eye protection and a dust
mask when operating or servicing
this tool.
• Piston and debris will exit the
conduit at high speed. Attach the
warning tag at the exit end of the
conduit before blowing a piston
through the conduit.
Failure to wear eye protection could
result in serious eye injury from flying
debris.
Use the 690 alone, or combine it with a 592 Mighty
Mouser Blow Gun Kit as shown here.
®
OPERATING TIPS
• When fishing through IMC or rigid, blowing is
generally more efficient than vacuuming.
• When fishing through EMT, vacuuming is the better
method. EMT connections are not airtight, and a
piston that is blown through might not reach the exit
end of the conduit run.
• Two fishing lines can be vacuumed in at the same
time, if desired. Leave one line in the conduit to
pull additional wire into the conduit after the initial
installation.
4455 Boeing Dr. • Rockford, IL 61109-2988 USA • 815-397-7070
48
47