Related Manuals for Armcor XEM 500
Summary of Contents for Armcor XEM 500
- Page 1 XEM INSTALLATION & OPERATION MANUAL XCHANGE ERV EXTERNAL MOUNT XEM 500, XEM 900, XEM 1200, XEM 1700, XEM 2000, XEM 2500, XEM 3500, XEM 4500, XEM 5000, XEM 6000, XEM 7000, XEM 8000...
-
Page 3: Equipment Application
Every proposed installation must be subject to an engineered design by a mechanical services consultant. Armcor Air Solutions is not responsible for performance of equipment in applications for which the equipment was not designed or specified. -
Page 4: Location Of Equipment
Armcor Air Solutions is not responsible for installation of Unless otherwise specified the following minimum access equipment in situations for which the equipment was should be available: not designed or specified. -
Page 5: Installation Instructions
Armcor Air Solutions perfect condition at the time at time of despatch. -
Page 6: Equipment Connections
(available the unit. on our website www.armcor.com.au) and are on the identification/serial no. plate attached to each unit. MAINS POWER SUPPLY AND FUSING • A single phase power supply rated at 240v (+/- 5%) 50Hz • All wiring must comply with relevant local wiring or a 3 phase power supply rated at 415 volts is required to regulations. - Page 7 XCHANGE ERV EXTERNAL MOUNT XEM - INSTALLATION & OPERATION MANUAL STANDARD EQUIPMENT LAYOUT These diagrams show units with EC Plug Fans. These layouts are also available for units fitted with Certrifugal Fans OPTION 1 EXHAUST AIR FRESH AIR SUPPLY AIR RETURN AIR OPTION 2 SUPPLY AIR...
-
Page 8: Maintenance Schedule
IMPORTANT: Failure to carry out regular maintenance with a licensed and reputable service company may render warranty claims invalid, if faults have been caused by lack of proper maintenance. Armcor Air Solutions may request to see the maintenance schedule carried out. -
Page 9: Warranty
• The system is installed in a mobile application (eg. caravan, boat, crane) HOW TO MAKE A WARRANTY CLAIM Complete a warranty form available on our website www.armcor.com.au and return the Armcor Warranty Request Form to: service@armcor.com.au Contact us direct by phone on 1800 244 556 or email service@armcor.com.au... -
Page 10: Pre-Start Checklist
XCHANGE ERV EXTERNAL MOUNT XEM - INSTALLATION & OPERATION MANUAL PRE-START CHECK LIST UNIT INSTALLATION AND CONNECTIONS Check that equipment is fully installed in accordance with the installation instructions Visually check that air flows will not be obstructed ELECTRICAL Visually check all field wiring Tighten all electrical connections including all factory wiring connections Ensure supply cable is correct size Check the required supply voltage is available on all phases... -
Page 11: Commissioning Checklist
XCHANGE ERV EXTERNAL MOUNT XEM - INSTALLATION & OPERATION MANUAL COMMISSIONING CHECKLIST GENERAL Air Filters: Overall Size and Number Drain Pipe Traps and Vents fitted to Indoor Unit as per Installation Instructions Y / N Drain is Clearing Water Properly Y / N Check Vibration of Unit OK / EXCESSIVE...
Need help?
Do you have a question about the XEM 500 and is the answer not in the manual?
Questions and answers