Page 1
SHINDAIWA OWNER’S/OPERATOR’S MANUAL M242S MULTIPURPOSE TOOL CARRIER M242 ■ Read this manual and the manuals provided with the Shindaiwa Splitboom Attachment series and familiarize yourself with its contents. ■ Minimize the risk of injury to yourself and others. ■ Always wear eye and hearing protection when operating this machine.
These procedures are guidelines for safe operation under most conditions, and are not intended to replace any safety rules and/or laws that may be in force in your area. If you have questions regarding your Shindaiwa hand held power equipment, or if you do not understand something in this manual, contact Shindaiwa Inc.
NEVER modify or disable any of the ALWAYS hold the unit firmly with both ing or loose fasteners and that the stop unit’s devices. Use only Shindaiwa genu- hands when cutting or trimming, and switch and throttle controls are working ine parts for repairs and maintenance.
Product Description Using the accompanying illustration as a guide, familiarize yourself with this unit and its various components. Understanding your unit helps ensure top performance, long service life and safer operation. Spark Plug M242 Multipurpose Tool Carrier Air cleaner Strap Grip Ignition Switch Throttle...
Transmission type Automatic, centrifugal clutch with bevel gear Specifications are subject to change without notice. *Shindaiwa One engine oil meets or exceeds these specifications and is recommended for all Shindaiwa products. With Shindaiwa SBA-TX24 Splitboom Attachment Sound Pressure Level *...
Assembly and adjustments Prior to assembly ■ This Shindaiwa Multipurpose Tool Carrier Kit containing this owner’s/operator’s WARNING! comes fully assembled. You only need manual and tool kit for routine mainte- Do not make unauthorized attach the accessory tool of your choice to nance.
Page 7
(3/16-1/4 inch). Tighten the locknut. Reinstall the air cleaner cover. Adjust as required to obtain 4-6 mm free play Adjusting the handle Your Shindaiwa Multi-Purpose Tool Car- Handle arrow rier comes with the handle installed. It can points toward coupler.
fied oil and also meets or exceeds ISO-L-EGD CAUTION! performance requirements. Shindaiwa One is recommended for use in all Shindaiwa low emis- Mix and pour fuel outdoors where there sions engines. Shindaiwa One also includes a are no sparks and flames.
Starting the Engine IMPORTANT! Engine ignition is controlled by a two position switch mounted on the throttle housing labeled, “I” for ON or START and “O” for OFF or STOP. WARNING! WARNING! WARNING! Keep all parts of your body Never start the engine from The cutting attachment may away from the rotating cutting attach- the operating position.
Specifications section. idle speed cannot be adjusted by the procedure described here, return the NOTE Adjusting engine idle trimmer to your Shindaiwa dealer for Carburetor fuel mixture adjustments are inspection. preset at factory and cannot be serviced in the field.
If a properly installed attachment vibrates, replace the attachment Use only authorized Shindaiwa parts and WARNING! with new one and re-check. accessories with your Shindaiwa trimmer. A cutting attachment shield or Do not make modifications to this unit with-...
COME OF A WARRANTY CLAIM. muffler is a fire hazard and may also cause hearing loss. NOTE: Using non-standard replacement parts could invalidate your Shindaiwa warranty. Daily maintenance ■ Make sure nuts, bolts, and screws Prior to each work day, perform the...
Page 13
Use a hooked wire to extract the fuel filter from inside the fuel tank. Inspect the fuel filter element. If it shows signs of contami- nation, replace with a genuine Shindaiwa replacement fuel filter element. CAUTION! Make sure you do not pierce the fuel line with the end of the hooked wire.
If the engine becomes sluggish and low on Remove the screen and clean it with a If you note excessive carbon buildup, con- power, check and clean the spark arrester stiff bristle brush. sult with an authorized Shindaiwa servic- screen. ing dealer. Long Term Storage ■...
Troubleshooting Guide ENGINE DOES NOT START What To Check Possible Cause Remedy Faulty recoil starter. Consult with an authorized servicing dealer. Fluid in the crankcase. Does the engine crank? Internal damage. Loose spark plug. Tighten and re-test. Good compression? Excess wear on cylinder, piston, Consult with an authorized rings.
Page 16
Troubleshooting Guide (continued) LOW POWER What To Check Possible Cause Remedy Operator is overworking the unit. Operate at slower rate. Carburetor mixture is too lean. Consult with an authorized Is the engine servicing dealer. overheating? Refill with fresh, clean unleaded gasoline with Improper fuel ratio.
Page 17
Troubleshooting Guide (continued) ADDITIONAL PROBLEMS What To Check Possible Cause Remedy Clean or replace the air filter. Clogged air filter. Replace the fuel filter. Clogged fuel filter. Poor acceleration. Consult with an authorized Lean fuel/air mixture. servicing dealer. Adjust idle. Check Specifications page Idle speed set too low.
Declaration of Conformity DECLARATION OF CONFORMITY We hereby declare the Shindaiwa Pole Pruner, Model SBA-P24 (SBA-P24/EU with M242/ EC2), meets the following respective requirements. Council Directives: Standard taken: 2004/108/EC as amended ISO 12100 - 1&2 98/37/EC as amended ISO 11806...
Page 19
Declaration of Conformity DECLARATION OF CONFORMITY We hereby declare the Shindaiwa Brushcutter, Model SBA-TX24 (SBA-TX24/EU with M242/EC2), meets the following respective requirements Council Directives: Standard taken: 2004/108/EC as amended ISO 12100 - 1&2 98/37/EC as amended ISO 11806 2000/14/EC as amended...
Page 20
Declaration of Conformity DECLARATION OF CONFORMITY We hereby declare the Shindaiwa Articulated Hedge trimmer, Model SBA-AH2422 (SBA- AH2422/EU with M242/EC2), meets the following respective requirements Council Directives: Standard taken: 2004/108/EC as amended ISO 12100 - 1&2 98/37/EC as amended ISO 11806...
Page 24
11975 SW Herman Rd. 6-2-11, Ozuka-Nishi, Part Number 65041-94310 Tualatin, Oregon 97062 Asaminami-Ku, Hiroshima Rev. 3/2009 U.S.A. 731-3167, Japan Shindaiwa is a registered trademark of Shindaiwa Inc. Telephone: 503 692-3070 Specifications subject to change without notice. Telephone: 81-82-849-2220 Fax: 503 692-6696 Fax: 81-82-849-2481...
Need help?
Do you have a question about the M242S and is the answer not in the manual?
Questions and answers