WeatherHawk myMET Pro Manual

Hand held wind meter

myMET Pro Manual V 1.00 — English

Product Description

Your myMET Pro Hand Held Wind Meter measures wind speed, air temperature, humidity, compass, pressure

and calculates wind chill. It then displays that information on the integral LCD, and transmits the information in

real-time to a BLE iOS or Android device within range using the myMET Pro app. All the information can be

tagged with an image and transmitted, using the methods available to the mobile device. NOTE: iPhone 4S or

later, iPad2 or later, and Android 4.2 or later devices are supported.

Your myMET Pro Hand Held Wind Meter package contains a myMET Pro, two Lithium CR2032 batteries

(installed), and a lanyard. BATTERIES: The batteries are factory installed. LANYARD: To install the lanyard,

feed the small loop through the hole at the bottom corner of the case, and then feed the lanyard through the loop.

myMET Pro USE: Extend myMET Pro to the fully opened position. If using a tripod, attach it at the bottom of

the case. NOTE: The optional wind vane accessory will align myMET Pro with wind direction when it is tripod

mounted and properly leveled. Hold myMET Pro at the bottom of the case, away from your face and body, to

avoid getting false readings. Your myMET Pro sensors are sensitive. For good measurements, it is

important that you do not touch, or obstruct, the sensors.

Table of Contents

Do you have a question about the myMET Pro and is the answer not in the manual?

Page 1: Product Description
Pro USE: Extend myMET Pro to the fully opened position. If using a tripod, attach it at the bottom of the case.
Page 2 When the myMET Pro is first turned on, it is defaulted to power off in 5 minutes; all units are in imperial scale; and the red backlight is always ON. These settings are adjustable on the device in the settings menu (“SET”...
Page 3 Units of Measure: myMET Pro measures wind speed in 2 different units of measure: Miles per Hour (mph) & Meters per Second (m/s). To switch between units of measure, please see the “Changing the Units of Measure” section for instructions.
Page 4 Battery: To replace the battery, turn the compartment cover in a clockwise direction to remove it. The battery will be visible in the battery compartment. Insert 2 new CR2032 lithium battery “+” side facing you. CR2032 batteries can be purchased anywhere batteries are sold. NOTE: Different modes have different effects on the battery life.