Table of Contents
Advertisement
4. Using Your Mass Charging Cabinet
NOTE: The Cabinets are designed to be stationary; casters are included only to initially position the Cabinet for setup in the
desired location.
4.1 Charging Your Computers
• After the devices have been loaded into the Cabinet, plug the power cord of the Cabinet into a suitable receptacle.
• For the models that have an Automated Power Controller included (MSC-60-CCN, MSC-60-CNN, MSC-72-CCN, and MSC-
72-CNN), locate the internal power switches on the Automated Power Controller and power strips of the Cabinet and push
the switches to the ON position.
4.2 Automated Power Controller Instructions
Before using your Automated Power Controller:
• For your safety, we recommend that a qualified electrician test the circuit you will plug the cart into. The circuit should be
checked for ground integrity and appropriate branch circuit protection.
• The cart's ground prong must be present for safe operation. If the plug is damaged or if the ground prong has been removed,
it should be replaced by a qualified electrician.
• Using the cart, including plugging it in or unplugging it, plugging in or unplugging the laptop(s) or other electrical equipment,
or operating the control switch must be done with adult supervision.
The timer comes preset from the factory to alternate power between the power strips at 15-minute intervals.
All power strips cannot charge simultaneously.
By
plugging the cart power cord into an approved outlet and flipping the red switches located on the automated power
controller and power strips,
To end power, turn the red switch on the timer off and unplug the cart from the wall outlet.
the cart will begin charging.
877-877-2269 | blackbox.com
Chapter 4: Using Your Mass Charging Cabinet
Page 23
Advertisement
Table of Contents
