Fastening The Power Bricks And Routing The Cable (Cabinets With Shelves Sized For Chromebook Computers And Laptops) - Black Box MSC-84-TCN User Manual

Chapter 3: Configuration and Setup
3.2 Fastening the Power Bricks and Routing the Cable (Applies to MSC-60, MSC-72, MSC-144, and
MSC-168 Part Numbers, Cabinets with Shelves sized for Chromebook Computers and Laptops)
1. Attach the wrapped cord and power brick to the back of the shelf using the hook and loop strap. Keep some extra cable
unwrapped to plug into the power strip.
2. Loosen the two screws on the cable manager, pull up on the top section of the cable manager, and place the device side of
the charging cable into one of the slots.
3. Replace the top section of the cable manager and tighten the screws.
4. Route the device side of the charging cable to the front of the cart and repeat step 2 for the front cable manager (see Figure
3-3).
5. Plug the charger power plug into the power strip located below the shelf.
Page 22
Loosen screws on
cable manager and
pull up
Cable
manager
Power block
and cord
Figure 3-3. Fastening the power brick and routing the cable.
877-877-2269 | blackbox.com
Route cable to the
front of the cart
Power strip