Calix T073G HGU ONT User Manual
Hide thumbs Also See for T073G HGU ONT:

Advertisement

T073G HGU ONT User Guide
November 2013
#220-00602, Rev 11

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the T073G HGU ONT and is the answer not in the manual?

Questions and answers

Summary of Contents for Calix T073G HGU ONT

  • Page 1 T073G HGU ONT User Guide November 2013 #220-00602, Rev 11...
  • Page 3: Table Of Contents

    Connecting Telephone (POTS) Service ..............14 Connecting Ethernet Service .................. 15 Verifying the Installation ..................15 Activating the ONT ..................16 Verifying Services ................... 17 Proprietary Information: Not for use or disclosure except by written agreement with Calix. © Calix. All Rights Reserved.
  • Page 4 Chapter 4: Troubleshooting ..........19 ONT Status LEDs ..................... 19 Troubleshooting Procedures .................. 21 Proprietary Information: Not for use or disclosure except by written agreement with Calix. © Calix. All Rights Reserved.
  • Page 5: Chapter 1: Product Description

    IPTV/VOD services  Two POTS (VoIP) service ports for voice services  Integrated IEEE 802.11b/g/n wireless (Wi-Fi)  One USB host port Proprietary Information: Not for use or disclosure except by written agreement with Calix. © Calix. All Rights Reserved.
  • Page 6: Features

     Rich set of LED indications for alarming and maintenance  Built-in capability for remote management such as supervision, monitoring, and maintenance Proprietary Information: Not for use or disclosure except by written agreement with Calix. © Calix. All Rights Reserved.
  • Page 7: Specifications

    1480 nm 1490 nm 1500 nm Sensitivity Minimum received power for -28 dBm BER<10 Overload Maximum received power for -8 dBm BER<10 Proprietary Information: Not for use or disclosure except by written agreement with Calix. © Calix. All Rights Reserved.
  • Page 8 Proprietary Information: Not for use or disclosure except by written agreement with Calix. © Calix. All Rights Reserved.
  • Page 9: Chapter 2: Safety

     This unit must only be used with the certified power adapter model inside the package, which complies with the requirement of a limited power source. Proprietary Information: Not for use or disclosure except by written agreement with Calix. © Calix. All Rights Reserved.
  • Page 10: Mounting Restrictions

    Caution! Do not bend the fiber optic cable to a diameter smaller than 7.5 cm (3 inches). Doing so may damage the fiber or prevent the signal from passing through properly. Proprietary Information: Not for use or disclosure except by written agreement with Calix. © Calix. All Rights Reserved.
  • Page 11: Chapter 3: Installation

    Chapter 3 Installation Get to Know the ONT The figures below provide a physical overview of the ONT. Proprietary Information: Not for use or disclosure except by written agreement with Calix. © Calix. All Rights Reserved.
  • Page 12: Connecting To The Pon Network

    2. Remove the dust covers from the SC/APC optical connector. Clean the connectors if necessary. 3. Plug in the fiber connector to connect the ONT to the network. Proprietary Information: Not for use or disclosure except by written agreement with Calix. © Calix. All Rights Reserved.
  • Page 13: Connecting Power

    4. Verify that the POWER LED on the ONT is lit (green) indicating that local power is on and voltage is within required limits. Proprietary Information: Not for use or disclosure except by written agreement with Calix. © Calix. All Rights Reserved.
  • Page 14: Connecting To An External Ups

    Connecting to an External UPS UPS power cord can be ordered from Calix. They are sold as 1 meter and 3 meter pre- terminated cables, as well as 6 meter un-terminated (UPS) cables. The UPS power cord is sold separate from the ONT package. The figure and table below show the PIN numbering of the UPS connector on the ONT.
  • Page 15: Connecting Ethernet Service

    PON network. If services must be verified at the time of installation, refer to Verifying Services (on page 17) for additional instructions. Proprietary Information: Not for use or disclosure except by written agreement with Calix. © Calix. All Rights Reserved.
  • Page 16: Activating The Ont

    Once the ONT has been activated in the network, and the AUTH LED is lit green, proceed to Verifying Services (on page 17). Proprietary Information: Not for use or disclosure except by written agreement with Calix. © Calix. All Rights Reserved.
  • Page 17: Verifying Services

     If WLAN service is included in this installation, confirm that data is being received and transmitted on WLAN interface. Verify the WLAN LED is green when the WLAN is connected. Proprietary Information: Not for use or disclosure except by written agreement with Calix. © Calix. All Rights Reserved.
  • Page 18 Proprietary Information: Not for use or disclosure except by written agreement with Calix. © Calix. All Rights Reserved.
  • Page 19: Chapter 4: Troubleshooting

    ONT Status LEDs The ONT status LEDs assist with installation and maintenance procedures. These LEDs are described below. T073G HGU ONT LEDs Proprietary Information: Not for use or disclosure except by written agreement with Calix. © Calix. All Rights Reserved.
  • Page 20 Green Blink USB interface has data transmission USB interface has no connection, or system power is off Proprietary Information: Not for use or disclosure except by written agreement with Calix. © Calix. All Rights Reserved.
  • Page 21: Troubleshooting Procedures

    The WLAN LED is off Check whether the WLAN service is enabled The USB LED is off Check whether the cable is normal Proprietary Information: Not for use or disclosure except by written agreement with Calix. © Calix. All Rights Reserved.
  • Page 22 Proprietary Information: Not for use or disclosure except by written agreement with Calix. © Calix. All Rights Reserved.

Table of Contents