Pioneer DVR-650H-S Operating Instructions Manual page 122

Additional information
15
HDMI
Problem
The connected HDMI or
DVI device does not
display any picture
(and the front panel
HDMI indicator does
not light)
No video from the
HDMI output
There's no sound from
the connected HDMI or
DVI device
The power
automatically turns on
Can't record video
122
En
Remedy
• Try disconnecting then reconnecting the HDMI cable (while the
power of both components is on).
• Try switching the power of the HDMI/DVI device off then back on.
• Try switching off the HDMI/DVI device and this recorder. Next, switch
on the HDMI/DVI device and leave it for around 30 seconds, then
switch on this recorder.
• When you connect an HDMI-compatible device make sure of the
following:
– The connected device's video input is set correctly for this unit.
– The cable you're using is fully HDMI-compliant. Using a non-
standard cable may result in no picture being output.
– Don't use several HDMI cables connected together. Use a single
cable to connect devices together.
• When you connect a DVI-compatible device make sure of the
following:
– The connected device's video input is set correctly for this unit.
– The DVI terminal on the connected device is HDCP-compatible.
– The connected device is compatible with NTSC (720 x 480i/p,
1280 x 720p, 1920 x 1080i/p) and PAL (720 x 576i/p, 1280 x 720p, 1920 x
1080i/p) video input.
• If the recorder's internal HDD is damaged or broken, there will be no
HDMI output.
• Not all HDCP-compatible DVI devices will work with this recorder.
• If you choose a setting that is incompatible with your TV you may not
be able to see any picture at all. In this case, press
while holding down the
the setting (this also switches Component Video Out on page 106 to
the default setting).
• There is no sound when using a DVI terminal.
• Some HDMI-compatible devices do not output sound (check with
the manual that came with the connected device).
• This unit's power may be turned on each time you turn on the power
for a connected plasma television. If you do not want this unit to be
turned on in this way, set this unit's HDMI Control to OFF (page 113).
• When using HDMI Control to record, you must make sure that the
channel information for the plasma television matches that of this
unit. If the channel information does not match you cannot make
recordings. Use the Auto Channel Setting function to set this unit's
channel information (page 105).
(Stop) button on the front panel to switch
OPEN/CLOSE