Table of Contents
Advertisement
Quick Links
WS4920 v1.0
Installation Instructions
NOTE: Use these instructions in conjunction with the installation manual of the alarm panel with which this equipment is intended to be used.
WARNING: READ and SAVE These Instructions! Follow All WARNINGS AND INSTRUCTIONS specified within these instruction and/or on the equipment.
2 9 0 0 7 8 5 6 R0 0 1
Advertisement
Table of Contents
Subscribe to Our Youtube Channel
Related Manuals for DSC WS4920
Summary of Contents for DSC WS4920
- Page 1 WS4920 v1.0 Installation Instructions NOTE: Use these instructions in conjunction with the installation manual of the alarm panel with which this equipment is intended to be used. WARNING: READ and SAVE These Instructions! Follow All WARNINGS AND INSTRUCTIONS specified within these instruction and/or on the equipment.
- Page 2 IMPORTANT: This equipment, WS4920 WIRELESS REPEATER 1.0 shall be used installed and used within an environment that provides the pollution degree max 2 and overvoltages category II NON HAZARDOUS LOCATIONS, indoor only. The equipment is FIXED and DIRECT PLUG IN powered from the mains; it is designed to be installed by Service Persons only; [Service Person is defined as a person having the appropriate technical training and experience necessary to be aware of hazards to which that person may be exposed in performing a task and of mea- sures to minimize the risks to that person or other persons.
-
Page 3: Specifications
Controls and Indicators Introduction jumper to prevent RF jam troubles from being The WS4920 has three LEDs on the front used The WS4920 is a wireless repeater designed to sent to the panel. When the jumper is open, RF to communicate information. - Page 4 F. Enroll/Placement test wireless devices with repeater G. Permanently mount WS4920. NOTE: When enrolling and placement testing the Terminals WS4920 with the alarm panel, refer to the panel installation instructions for the appropriate pro- gramming sections. A: Temporarily Mount WS4920 Select a suitable location for the repeater.
- Page 5 To test the RF link between the WS4920 and •Door and window contact open/close or tam- D: Enrolling the WS4920 the alarm panel: per/restore The WS4920 has two Electronic serial numbers 1.Place alarm panel into placement test (see •PIR and other stationary devices tamper/...
-
Page 6: Restoring The Ws4920 To Factory Defaults
3 seconds or place cover back on WS4920. NOTE: The second button press must occur within “Mode Exited” tone sounds. 30 seconds of the first or the WS4920 will exit Global Placement Testing Devices Enroll/Placement mode. To placement test a 1-way wireless device after 3.WS4920 beeps three times indicating Installer... -
Page 7: Limited Warranty
EULA are reserved by DSC and its suppliers. tract. If You do not agree to the terms of this EULA, DSC is unwilling to license the replace the defective equipment upon return of the equipment to its repair depot. This warranty 4. - Page 8 NMB-003 du Canada. without notice. Actual products may vary from photos. tee that interference will not occur in a particular installa- IC:160A-WS4920 Not all products include all features. Availability varies by tion. If this equipment does cause interference to The term IC before the radio certification number signifies region;...
Need help?
Do you have a question about the WS4920 and is the answer not in the manual?
Questions and answers