Advertisement
Caring for Nevo
Use only the stylus or your finger to switch Nevo
sharp objects.Clean your controller with a soft, damp cloth using a gentle, non-
caustic cleaner.
Do not use a caustic or abrasive cleaner. This may damage the
C
:
AUTION
surface of your controller.
For more information, contact
your installer/integrator:
NOTICE: Nevo, NevoStudio, NevoStudio Pro, Nevo
trademarks or trademarks of Universal Electronics Inc., in the United States and/or other
countries. Other product and company names may be trademarks of their respective
companies.
FCC NOTICE: This equipment has been tested and found to comply with the limits for a class
B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide
a reasonable protection against harmful interference in a residential installation. This
equipment generates, uses, and can radiate radio frequency energy if not installed and used
in accordance with the instructions, and may cause harmful interference to radio
communications. However, there is no guarantee that interference will not occur in a
particular installation. If this equipment does cause harmful interference to radio or
television reception, which can be determined by turning the equipment off and on, the user
is encouraged to try to correct the interference by one or more of the following measures:
•
Reorient or relocate the receiving antenna.
•
Increase the separation between the equipment and the receiver.
•
Connect the equipment into an outlet or a circuit different from that to which the receiver is
connected.
•
Consult the dealer or an experienced radio/TV technician for help.
Operation is subject to the following two conditions: (1) this device may not cause harmful
interference, and (2) this device must accept any interference received, including
interference that may cause undesired operation.
This equipment has been verified to comply with the limits for a class B computing device,
pursuant to FCC Rules. In order to maintain compliance with FCC regulations, shielded
cables must be used with this equipment. Operation with non-approved equipment or
unshielded cables is likely to result in interference to radio and TV reception.
This equipment complies with FCC radiation exposure limits set forth for an uncontrolled
environment. In order to avoid the possibility of exceeding the FCC radio frequency exposure limits,
human's body proximity to the device should not be less than 2.5 cm during normal operation.
WARNING: Changes or modifications of this equipment not expressly approved by the party
responsible for compliance could void the user's authority to operate the equipment.
FCC ID: MG372400
IC ID: 2575A-URC7240
CAUTION: RISK OF EXPLOSION IF BATTERY IS REPLACED BY AN INCORRECT TYPE.
DISPOSE OF USED BATTERIES ACCORDING TO THE INSTRUCTIONS.
The socket-outlet shall be installed near the equipment and shall be easily accessible.
The equipment is to be supplied from an identified USB port complying with the
requirements of Limited Power Source.
Corporate Headquarters
Universal Electronics
6101 Gateway Drive
Cypress, CA 90630-4841
714-820-1000
www.uei.com
Copyright © 2008 Universal Electronics Inc
All rights reserved.
S70
Installer/integrator: attach your
business card or business
sticker here.
S70
on or off. Avoid using
S70
and NevoConnect are registered
International Headquarters
Universal Electronics
Institutenweg 21
7521 PH Enschede
The Netherlands
+31 53.488.8000
www.uei.com
Document version NS70QGP100108
Advertisement
