Table of Contents
Advertisement
Playback
To start playback on the digital recorder, make sure that it is in standby mode. First stop recording if active
(only the green ON/OFF LED should be on). Proceed as follows:
1. Briefly press Playback (3).
The red playback LED lights up.
2. Briefly press Enter (9).
Playback ends after a few seconds.
3. Press Enter (9) again.
Playback starts with the oldest recorded data.
The monitor displays the following:
2004-01-01 12:00:00
PLAY -> STOP
To change the playback direction, briefly press Reverse or Enter (8 or 9).To stop playback, briefly press Stop
(c).
The red playback LED switches off.The live picture is displayed.
The arrow (< - >) next to PLAY shows the playback direction.
The number in the top right corner shows the playback speed.
60P
Blade-900_19
Advertisement
Table of Contents
