Hard Disk - REC Blade-900 Installation Instructions Manual

Hard disk

Use only the hard-disk models recommended for this purpose.
Fitting the hard disk
1.Switch off the digital recorder and open the hard disk slot.
2.Turn the handle to face upwards and pull the HDD frame carefully out of the slot.
(Keys and fitting screws are contained in the HDD frame.)
3.Push the plastic lock of the HDD frame cover down and push the upper cover of the HDD frame back.
4.Change the hard disk jumper so that the hard disk works as MASTER.
5.Connect the hard disk supplied to the HDD frame using a 4-pole power cable and a flat ribbon data cable.
6.Fix the hard disk with two screws on the left and two screws on the right of the HDD frame and then close
the frame with the upper cover.
7.Insert the HDD frame back into the slot, push it until engages, and turn the handle to face down.
Now lock the hard disk with the key.
Blade-900_10