Table of Contents
Advertisement
DigiSpeed-GX™
3 Features
The main features of the DigiSpeed-GX™ controller are;
•
Controlled by a RISC Microchip micro-controller.
•
PCB
FR4 Material
o
Double Sided, Plated through holes
o
Silk-Screened on Component Side
o
Solder Mask on Both Sides
o
•
Small PCB footprint 2"(L) x 1"(W)
•
Four 4mm mounting holes (supplied with matching stand-offs)
•
5V dc XXXmA power requirements.
•
Opto-isolation between the computer logic Voltages and the analolg output control voltages.
•
Maximum DC Speed controller voltage for the control supply of 15Vdc
•
10 bit resolution providing more than 1000 steps from 0 to Max Output voltage.
•
Four methods to control motor speed.
0-5V analog Voltage
o
PWM - A low frequency PWM signal. (2Hz – 100Hz )
o
On-Board multi-turn trimpot
o
•
Output Control Voltage Attenuator.
•
SMT LED indicating the mode and state of the DigiSpeed-GX™ controller.
•
Pluggable 3.5mm terminal block connectors for easy installation and maintenance.
Copyright 2006 ©
- Users Guide
Homann Designs
Page 8
Revision 0.1
Advertisement
Table of Contents
