Selecting Languages Using The Language Code; List; Troubleshooting - Pioneer DV-400V-K Operating Instructions Manual

09
Additional information
Selecting languages using the
language code list
Some of the language options (such as 'DVD
Menu Lang.' in the Initial Settings) allow you to
set your preferred language from any of the
136 languages listed in the language code list
on page 61.

Troubleshooting

Incorrect operation is often mistaken for trouble or malfunction. If you think that there is
something wrong with this component, check the points below. Sometimes the trouble may lie
in another component. Inspect the other components and electrical appliances being used. If
the trouble cannot be rectified after checking the items below, ask your nearest Pioneer
authorized service center or your dealer to carry out repair work.
Problem
The disc won't play or is
automatically ejected
after loading.
DVD-Audio playback
stops.
Picture playback stops
and the operation
buttons cannot be used.
New settings made in the
Setup screen menus while
a disc is playing are
ineffective.
54
En
1
2
buttons to select either a code letter or a
code number.
3
to select a code letter or a code number.
See Language code list on page 61 for a
complete list of languages and codes.
Remedy
• Make sure the disc is free from dirt and dust and is not damaged
(page 51).
• Make sure the disc is loaded with the label side face-up and aligned
properly in the disc tray guide.
• Incompatible region number: If the region number on a DVD-Video
disc does not match the number on the player, the disc cannot be
used (page 53). In this case the attention sentence "Incompatible disc
region number Can't play disc" is displayed on screen.
• Condensation inside the player: Allow time for condensation to
evaporate. Avoid using the player near an air-conditioning unit.
• Disc is loaded upside down: Reload the disc with the label side face
up.
• A Super VCD that does not conform with the IEC standards might
not play normally.
• The disc may have been illegally copied.
• Press , then start playback again ( ).
• Press and hold the front panel
seconds to switch the unit off, then press again to switch back on.
• Switch the power off once, unplug from the wall socket, then plug
back in and switch on again using the front panel
button.
• Some settings can be changed while a disc is playing, but are not
effective until the disc is stopped then restarted: Press
playback again ( ).
Select 'Other Language'.
Use the (cursor left/right)
Use the (cursor up/down) buttons
STANDBY/ON button for about 10
STANDBY/ON
, then start