Message Table; Indicator Display - Hitachi CP-X980W Service Manual

CP-X980W
CP-X985W

Message table

On-screen display
The following messages are displayed on the screen.
"CHANGE THE LAMP"
"AFTER REPLACING LAMP, RESET
THE LAMP TIMER"
"CHANGE THE LAMP"
"AFTER REPLACING LAMP,
RESET THE LAMP TIMER"
"THE POWER WILL TURN OFF
AFTER 20 Hr."
Blinking of "CHANGE THE LAMP"
"AFTER REPLACING LAMP,
RESET THE LAMP TIMER"
"THE POWER WILL TURN OFF
AFTER 0 Hr."
"NO INPUT IS DETECTED"
"SYNC IS OUT OF RANGE"

Indicator display

The POWER indicator, LAMP indicator and TEMP indicator will light or blink in the following cases.
POWER indicator LAMP indicator TEMP indicator
Lights orange
Blinks green
Lights green
Blinks orange
Lights red
Lights red
Lights red
When inside temperature becomes high, to protect the projector, the lamp may be turned off and the lamp indicator
lights red, or the projector will be shut down and the all indicator display goes off.
6
Lamp has 1,300 hours on it and may need to be changed.
Lamp has 1,979 hours on it.
See P.6 "Reset the lamp timer"
When the lamp has 1,300 hours or more on it, the message will blink, and
the power will turns off after 10 minutes.
Signal is not input.
The horizontal or vertical frequency of the input signal exceeds the range
of the projector, it cannot be displayed.
Goes off Goes off
Goes off Goes off
Goes off Goes off
Goes off Goes off
Lights red Goes off
Goes off
Blinks red
Goes off
Blinks red
Meaning
Standby mode
During warming up
During operation
During cooling down
Lamp cannot light
Lamp is not inserted or
lamp door is not closed.
Cooling fan accidented
Remedy
Cool projector by power off for
60 minutes.
If the indicator is still lit, lamp
may be defective. Replace.
Securely insert the lamp or
close the lamp door.
Replace fan.