Message Table - Hitachi CP-X325W Service Manual

Message table

On-screen display
The following messages are displayed on the screen.
"CHANGE THE LAMP"
"AFTER REPLACING LAMP, RESET
THE LAMP TIMER"
"CHANGE THE LAMP"
"AFTER REPLACING LAMP,
RESET THE LAMP TIMER"
"THE POWER WILL TURN OFF
AFTER 20 Hr."
Blinking of "CHANGE THE LAMP"
"AFTER REPLACING LAMP,
RESET THE LAMP TIMER"
"THE POWER WILL TURN OFF
AFTER 0 Hr."
"NO INPUT IS DETECTED"
"SYNC IS OUT OF RANGE"
"CHECK THE AIR FLOW"
Indicator display
The ON indicator, LAMP indicator and TEMP indicator will light or blink in the following cases.
ON indicator LAMP indicator TEMP indicator
Lights orange
Goes off
Goes off
Blinks green
Lights green Goes off
Goes off
Blinks orange
Lights red
Lights red
Lights red Blinks red
Goes off
Lights red
Goes off
Lights red
When inside temperature becomes high, to protect the projector, the lamp may be turned off and the lamp indicator
lights red, or the projector will be shut down and the all indicator display goes off.
Lamp has 1,700 hours on it and may need to be changed.
Lamp has 1,979 hours on it.
See "Reset the lamp timer"
When the lamp has 2,000 hours or more on it, the message will blink, and the
power will turns off after 10 minutes.
Signal is not in.
The horizontal or vertical frequency of the input signal exceeds the range of
the projector, it cannot be displayed.
Please remove the obstruction before the suction port.
Standby mode
Goes off
Goes off
During warming up
Goes off During operation
Goes off
During cooling down
Goes off Lamp cannot light
Lamp is not inserted or
Goes off
Lamp cover is open
Cooling fan accidented or PWB
Blinks red
ass'y SENSOR accidented.
Inside temperature becomes
Lights red
high
– 21 –
Meaning
Cool projector by power off for
20 minutes.
If the indicator is still lit, lamp
may be defective. Replace.
Securely insert the lamp or
shut the lamp door.
Replace fan, PWB ass'y SENSOR
or connect CNTH.
Please remove the obstruction
before the suction port.
CP-X325W
Remedy