Advertisement
Page 5 • JL Audio, Inc., 2016
S T E P 9
Slide a U-Nut in the proper direction back into the
rectangular hole, and lightly tap it into place with a hammer
until it's aligned with the 9/16" hole drilled in the previous
step.
S T E P 1 0
Pictured is the U-Nut in the final position.
Repeat Steps 6-9 for the second rectangular hole.
S T E P 1 1
Pull the plastic air boxes off of the studs on the back of the
cab.
S T E P 1 2
Pictured are the brackets and associated hardware needed in
the following steps.
SB-GM-SLVCRW/10TW3 INSTR_SKU# 011364
S T E P 1 3
Slide a U-Nut over a Long Bracket, aligning it with the hole
near the bend. Thread a 3/8 - 16 x 2-1/4" Set Screw into the
U-Nut as shown.
S T E P 1 4
Align the hole in the Large Bracket with the U-Nut as shown.
Thread a 3/8 - 16 x 3/4" Flange Bolt through the Large Bracket
and into the U-Nut. Align the Large Bracket vertically.
S T E P 1 5
Determine which slotted hole in the Large Bracket and
which direction will work for aligning the Small Bracket with
the stud shown in Step 11.
Assemble the Small Bracket to the Large Bracket as needed
using a 1/4 -20 x 1/2" Flange Bolt and 1/4" Flange Nut.
S T E P 1 6
Place a 1/4" Spacer over the stud, followed by the Small
Bracket. Keep the Large Bracket aligned vertically and
tighten all hardware.
Continued on Next Page
Advertisement
